Dimensions and weights *1: Unladen vehicles Vehicle identification ■ Vehicle identification number The vehicle identification number (VIN) is the legal identifier for your vehicle. This is the primary identification number for your Toyota. It is used in registering the ownership of your vehicle. This number is stamped on the top left of the instrument panel. This number is also on the Certification Label. ■ Engine number The engine number is stamped on the engine block as shown. Engine Fuel *: Vehicles with 215/55R17 tires Lubrication system *: The engine oil capacity is a reference quantity to be used when changing the engine oil. Warm up and turn off the engine, wait more than 5 minutes, and check the oil level on the dipstick. ■ Engine oil selection "Toyota Genuine Motor Oil" is used in your Toyota vehicle. Use Toyota approved "Toyota Genuine Motor Oil" or equivalent to satisfy the following grade and viscosity. Oil grade: ILSAC GF-5 multigrade engine oil Recommended viscosity: SAE 0W-20 SAE 0W-20 is the best choice for good fuel economy and good starting in cold weather. If SAE 0W-20 is not available, SAE 5W-20 oil may be used. However, it must be replaced with SAE 0W- 20 at the next oil change. Oil viscosity (0W-20 is explained here as an example):
How to read oil container label: The International Lubricant Specification Advisory Committee (ILSAC) Certification Mark is added to some oil containers to help you select the oil you should use. Cooling system Ignition system
Electrical system Automatic transaxle *: The fluid capacity is a reference quantity. If replacement is necessary, contact your Toyota dealer.
Brakes *: Minimum pedal clearance when depressed with a force of 67 lbf (300 N, 31 kgf) while the engine is running. Steering Tires and wheels 17-inch tires 18-inch tires 19-inch tires Light bulbs*
*: Light bulbs not listed in this table are LED bulbs. |
Toyota Avalon (XX50) 2019-2022 Service & Repair Manual > Tilt And Telescopic Manual Switch: Installation
INSTALLATION PROCEDURE 1. INSTALL TILT AND TELESCOPIC SWITCH (a) Engage the claw to install the tilt and telescopic switch. (b) Connect the tilt and telescopic connector to the tilt and telescopic switch. (c) Connect the spiral cable connector to the spiral cable sub-assembly. 2. CONNECT CABLE TO NE ...