DESCRIPTION The hybrid
vehicle control ECU alerts the driver and performs fail-safe control
based on error signals received from the battery voltage sensor. This
DTC is stored when the SOC (state of charge) of the HV battery has
dropped excessively as a result of leaving shift lever in N, running out
of fuel, or a malfunction in the hybrid system. |
DTC No. | Detection Item |
DTC Detection Condition | Trouble Area |
MIL | Warning Indicate | |
P300000 | Hybrid/EV Battery Discharge Control Malfunction |
Discharging prohibited Discharging
of the HV battery continues even after discharging is prohibited when
the hybrid system is malfunctioning and "Hybrid Battery SOC" has reached
the lower limit. (1 trip detection logic) |
- SFI system
- Fuel level
- HV battery
| Does not come on |
Master Warning Light: Does not come on | Related Data List |
DTC No. | Data List | |
P300000 |
- Hybrid Battery SOC
- WOUT Control Limit Power
- Hybrid Battery Current
| CONFIRMATION DRIVING PATTERN
HINT: After
repair has been completed, clear the DTC and then check that the
vehicle has returned to normal by performing the following All Readiness
check procedure. Click here 
- Connect the Techstream to the DLC3.
- Turn the power switch on (IG) and turn the Techstream on.
- Clear the DTCs (even if no DTCs are stored, perform the clear DTC procedure).
- Turn the power switch off and wait for 2 minutes or more.
- Turn the power switch on (IG) and turn the Techstream on.
- Turn the power switch on (READY) with shift lever in P and cause the
"Hybrid Battery SOC" to decrease. Check that the engine is started to
charge the HV battery, and the value of Data List item "Hybrid Battery
SOC" increases and then remains within an appropriate range.
- Enter the following menus: Powertrain / Hybrid Control / Utility / All Readiness.
- Check the DTC judgment result.
HINT:
- If the judgment result shows NORMAL, the system is normal.
- If the judgment result shows ABNORMAL, the system has a malfunction.
- If the judgment result shows INCOMPLETE or N/A, perform driving pattern again.
CAUTION / NOTICE / HINT
HINT:
- If the vehicle is left with shift lever in N (parked or stopped) for a
long time, the battery cannot be charged. In this case, the SOC may drop
below the lower limit and DTC P300000 may be stored. (This is not a
system malfunction.)
- When the engine cannot be started, DTC P300000 may be stored because the HV battery cannot be charged.
- Repeated engine start checks may cause the SOC to drop, resulting in DTC
P300000 being stored. In this case, charge the HV battery using the THS
charger.
- Cranking the engine once causes the SOC to drop approximately 1%.
- Charging the HV battery once (10 minutes) using the THS charger restores the SOC approximately 2%.
- Charging the HV battery using the THS charger takes approximately 10
minutes when the battery temperature is 25°C (77°F) or approximately 30
minutes when the battery temperature is 0°C (32°F).
- The THS charger is a supplemental charging device that enables the hybrid system to start (READY-on state).
- If the result of this inspection is to charge the HV battery, clear the
DTCs and then charge the HV battery using the THS charger.
PROCEDURE |
1. | CHECK DTC OUTPUT (HYBRID CONTROL) |
(a) Connect the Techstream to the DLC3. (b) Turn the power switch on (IG).
(c) Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.
(d) Check for DTCs. Powertrain > Hybrid Control > Trouble Codes
|
Result | Proceed to | |
P300000 or P300016 only is output. |
A | | DTCs other than P300000 and P300016 are also output. |
B | (e) Turn the power switch off.
| B |
 | GO TO DTC CHART (HYBRID CONTROL SYSTEM) |
|
A |
 | |
| 2. |
CHECK DTC OUTPUT (ENGINE) | (a) Connect the Techstream to the DLC3.
(b) Turn the power switch on (IG). (c) Enter the following menus: Powertrain / Engine / Trouble Codes.
(d) Check for DTCs. Powertrain > Engine > Trouble Codes
|
Result | Proceed to | |
No DTCs are output. | A | |
DTCs are output. | B |
(e) Turn the power switch off.
| B | |
GO TO DTC CHART (SFI SYSTEM) |
|
A | |
| |
(a) Turn the power switch on (IG).
(b) Check the amount of fuel by referring to the fuel gauge in the meter.
HINT: Add fuel until the low fuel level warning light turns off.
|
Result | Proceed to | |
Proper amount of fuel is in the tank. |
A | | There is no fuel in the tank. |
B | (c) Turn the power switch off.
| B |
| REFUEL VEHICLE |
|
A | |
| |
| 4. |
CHECK FREEZE FRAME DATA | (a) Connect the Techstream to the DLC3.
(b) Turn the power switch on (IG). (c) Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.
(d) Read the freeze frame data item "Shift Position" of DTC P300000. Powertrain > Hybrid Control > Trouble Codes Powertrain > Hybrid Control
|
Tester Display | | Shift Position |
NOTICE:
- When the freeze frame data "Shift Position" was N, DTC P300000 may be
stored due to the vehicle was left with shift lever in N and the HV
battery could not be charged.
- If DTC "P300000" only is output, charge the HV battery without replacing the HV battery if necessary.
(e) Turn the power switch off.
|
NEXT | |
| |
(a) Turn the power switch on (READY).
(b) Check if the engine starts.
HINT:
- Depressing the accelerator pedal with shift lever in P will cause the engine to start.
- Turning the power switch on (READY) and off repeatedly while the SOC is
low may cause the SOC to drop further, resulting in DTC P300016 being
stored. Charge the HV battery using the THS charger as necessary.
- Cranking the engine once causes the SOC to drop approximately 1%.
- Charging the HV battery once (10 minutes) using the THS charger restores the SOC approximately 2%.
|
Result | Proceed to | |
The engine starts. | A | |
The engine does not start. |
B | (c) If the engine does not start, turn the power switch off.
| A |
| LEAVE VEHICLE WITH SHIFT LEVER IN P, AND CHARGE HV BATTERY BY IDLING UNTIL IDLING STOPS |
|
B | |
| |
Click here
| NEXT | |
CHARGE HV BATTERY (CHECK THAT ENGINE STARTS) | | 
