Toyota Avalon (XX50) 2019-2022 Service & Repair Manual: Installation

INSTALLATION

PROCEDURE

1. INSTALL INVERTER WATER PUMP ASSEMBLY

(a) Connect the No. 2 inverter cooling hose and No. 3 inverter cooling hose to the inverter water pump assembly and slide the 2 clips to secure them. NOTICE: To prevent foreign matter from entering the inverter water pump assembly and inverter cooling system, do not remove the pieces of cloth from the pipes and disconnected hoses until installation. If the inverter water pump assembly has been struck or dropped, replace it. HINT: Make sure to align the alignment marks of the hoses with the ribs of the inverter water pump assembly. Make sure that the clips are positioned as shown in the illustration.

*1 No. 2 Inverter Cooling Hose *2 No. 3 Inverter Cooling Hose *a Alignment Mark (Pink) *b Alignment Mark (Yellow) *c Rib *d 2 to 7 mm (0.0787 to 0.276 in.) *e Up *f Front of Vehicle *g RH Side

(b) Temporarily install the inverter water pump assembly to the fan shroud assembly with the 2 bolts.

(c) Fully tighten the 2 bolts.

Torque:

7.0 N·m {71 kgf·cm, 62 in·lbf}

NOTICE:

As overtightening the bolts may damage the fan shroud assembly, make sure to use a torque wrench.

(d) Connect the inverter water pump assembly connector.

NOTICE:

If a dustproof cap is installed to the inverter water pump assembly connector, do not remove it until the connector is to be connected.

2. ADD COOLANT (for Inverter)

Click here

3. INSPECT FOR COOLANT LEAK (for Inverter)

Click here

4. INSTALL NO. 1 ENGINE UNDER COVER

Click here

5. INSTALL FRONT WHEEL OPENING EXTENSION PAD LH

Click here

6. INSTALL FRONT WHEEL OPENING EXTENSION PAD RH

Click here