REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced generator assembly removal/installation are shown below. Necessary Procedures After Parts Removed/Installed/Replaced
PROCEDURE 1. PRECAUTION NOTICE: After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work. Click here
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL NOTICE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected. Click here 3. REMOVE RADIATOR ASSEMBLY Click here 4. REMOVE V-BANK COVER SUB-ASSEMBLY Click here 5. REMOVE V-RIBBED BELT Click here 6. REMOVE GENERATOR ASSEMBLY
(b) Remove the nut and disconnect the wire harness from terminal B. (c) Remove the 2 bolts.
(e) Disconnect the compressor assembly with magnetic clutch connector. (f) Disconnect the camshaft timing oil control solenoid assembly connector. (g) Disengage the 3 wire harness clamps and remove the wire harness clamp bracket.
| ||||||||||||||||||||||||||||||||||||||||
Toyota Avalon (XX50) 2019-2022 Service & Repair Manual > Radiator: Installation
INSTALLATION PROCEDURE 1. INSTALL LOWER RADIATOR SUPPORT (a) Install the 2 lower radiator supports to the radiator assembly. 2. INSTALL RADIATOR SUPPORT CUSHION (a) Install the 2 radiator support cushions to the radiator assembly. 3. INSTALL RADIATOR ASSEMBLY (a) Engage the 2 guides. (b) Engage the ...
