DESCRIPTION
Detection Item | Symptom |
Trouble Area | Headlight ECU RH Communication Stop Mode |
Any of the following conditions are met:
- Communication stop for "HL AutoLeveling/AFS/AHS (Sub)" is indicated on the "Communication Bus Check" screen of the Techstream.
Click here
- Communication stop history for "HL AutoLeveling/AFS/AHS (Sub)" is
indicated on the "Communication Bus Check (Detail)" screen of the
Techstream. (The Lost Communication Time value for "HL
AutoLeveling/AFS/AHS (Sub)" is 6 or more.)
Click here
- Communication system DTCs (DTCs that start with U) that correspond to
"Headlight ECU RH Communication Stop Mode" in "DTC Combination Table"
are output.
Click here
|
- Headlight ECU sub-assembly RH branch line or connector
- Power source circuit of headlight ECU sub-assembly RH
- Headlight ECU sub-assembly RH ground circuit
- Headlight ECU sub-assembly RH
| WIRING DIAGRAM
CAUTION / NOTICE / HINT
CAUTION: When performing the confirmation driving pattern, obey all speed limits and traffic laws.
NOTICE:
HINT:
- Before disconnecting related connectors for inspection, push in on each
connector body to check that the connector is not loose or disconnected.
- When a connector is disconnected, check that the terminals and connector body are not cracked, deformed or corroded.
PROCEDURE
1. | CHECK FOR OPEN IN CAN BUS LINES (HEADLIGHT ECU SUB-ASSEMBLY RH BRANCH LINE) |
(a) Disconnect the cable from the negative (-) battery terminal. (b) Disconnect the A9 headlight ECU sub-assembly RH connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection | Condition |
Specified Condition |
A9-24 (CANH) - A9-23 (CANL) |
Cable disconnected from negative (-) battery terminal |
54 to 69 Ω | |
|
*a | Front view of wire harness connector
(to Headlight ECU Sub-assembly RH) | | |
NG |
| REPAIR OR REPLACE CAN BRANCH LINES OR CONNECTOR (HEADLIGHT ECU SUB-ASSEMBLY RH) |
OK |
| |
2. |
CHECK HARNESS AND CONNECTOR (POWER SOURCE CIRCUIT) |
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection | Condition |
Specified Condition |
A9-12 (GND) - Body ground |
Cable disconnected from negative (-) battery terminal |
Below 1 Ω | |
|
*a | Front view of wire harness connector
(to Headlight ECU Sub-assembly RH) | | |
(b) Reconnect the cable to the negative (-) battery terminal. (c) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Tester Connection | Condition |
Specified Condition |
A9-4 (IG) - Body ground |
Engine switch on (IG) |
11 to 14 V |
OK |
| REPLACE HEADLIGHT ECU SUB-ASSEMBLY RH |
NG |
| REPAIR OR REPLACE HARNESS OR CONNECTOR (POWER SOURCE CIRCUIT) | |