Toyota Avalon (XX50) 2019-2022 Service & Repair Manual: ECU Malfunction (B1003)

DESCRIPTION

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

Note

B1003

ECU Malfunction

A malfunction in the non-volatile storage of the central gateway ECU (network gateway ECU) is detected.

Central gateway ECU (network gateway ECU)

-

PROCEDURE

1.

RECONFIRM DTC OUTPUT

(a) Connect the Techstream to the DLC3.

(b) Turn the power switch on (IG).

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / Central Gateway / Trouble Codes.

Body Electrical > Central Gateway > Trouble Codes

Result

Proceed to

DTC B1003 is not output from the central gateway ECU (network gateway ECU)

A

DTC B1003 is output from the central gateway ECU (network gateway ECU)

B

A

USE SIMULATION METHOD TO CHECK

B

REPLACE CENTRAL GATEWAY ECU (NETWORK GATEWAY ECU)

    Air Conditioning Amplifier Communication Stop Mode

    Blind Spot Monitor Sensor Communication Stop Mode

    See More:

    Toyota Avalon (XX50) 2019-2022 Service & Repair Manual > Sfi System: Mass or Volume Air Flow Sensor "A" Circuit Short to Battery (P010012,P010014)
    DESCRIPTION The mass air flow meter sub-assembly is a sensor that measures the intake air volume using the following built-in components: By-pass duct (allows some of the intake air to flow past a silicon chip sensor) Silicon chip sensor (uses a heater control bridge circuit and temperature sensor b ...

    Toyota Avalon (XX50) 2019-2022 Owners Manual

    Toyota Avalon (XX50) 2019-2022 Service & Repair Manual

    © 2024 Copyright www.tavalon.net
    0.0296