Toyota Avalon (XX50) 2019-2022 Service & Repair Manual: PIG Power Supply Voltage (C1552,C1554)

DESCRIPTION

When a malfunction is detected in the PIG power source and power supply relay system, the fail-safe function suspends power assist.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

Warning Indicate

Return-to-normal Condition

Note

C1552

PIG Power Supply Voltage

PIG power source circuit malfunction

  • EPS fuse
  • Harness or connector
  • Rack and pinion power steering gear assembly

EPS warning light: Comes on

Engine switch on (IG) again

-

C1554

Power Supply Relay Failure

Power source relay circuit malfunction

  • EPS fuse
  • Harness or connector
  • Rack and pinion power steering gear assembly

EPS warning light: Comes on

Engine switch on (IG) again

-

WIRING DIAGRAM

CAUTION / NOTICE / HINT

NOTICE:

  • If the rack and pinion power steering gear assembly has been replaced, perform assist map writing and torque sensor zero point calibration.

    Click here

  • Inspect the fuses for circuits related to this system before performing the following procedure.

PROCEDURE

1.

CHECK HARNESS AND CONNECTOR (RACK AND PINION POWER STEERING GEAR ASSEMBLY - BODY GROUND)

(a) Disconnect the C67 rack and pinion power steering gear assembly connector.

*a

Front view of wire harness connector (to Rack and Pinion Power Steering Gear Assembly)

-

-

(b) Measure the voltage according to the value(s) in the table below.

Standard Voltage:

Tester Connection

Condition

Specified Condition

C67-8 (PIG) - Body ground

Always

9 to 16 V

(c) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

C67-7 (PGND) - Body ground

Always

Below 1 Ω

OK

REPLACE RACK AND PINION POWER STEERING GEAR ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

    IG Power Supply Voltage (C1551)

    Error in Matching of ECUs (C1567)

    See More:

    Toyota Avalon (XX50) 2019-2022 Service & Repair Manual > Electronically Controlled Brake System(for Hv Model): Increasing Pressure Solenoid (FR) (C1352-C1359)
    DESCRIPTION Each solenoid adjusts the pressure which affects each wheel cylinder according to signals from the skid control ECU (brake booster with master cylinder assembly) and controls the vehicle. DTC No. Detection Item INF Code DTC Detection Condition Trouble Area MIL Note C1352 Increasing Press ...

    Toyota Avalon (XX50) 2019-2022 Owners Manual

    Toyota Avalon (XX50) 2019-2022 Service & Repair Manual

    © 2024 Copyright www.tavalon.net
    0.0206