CAUTION / NOTICE / HINT
HINT:
- Use the following procedure to troubleshoot the power steering system.
- *: Use the Techstream.
PROCEDURE |
1. | VEHICLE BROUGHT TO WORKSHOP |
|
NEXT |
 | |
(a) Turn the engine switch off.
(b) Measure the voltage of the battery. Standard Voltage: 11 to 14 V
HINT: If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.
|
NEXT | |
| |
| 3. |
CHECK DTC AND FREEZE FRAME DATA* | HINT:
Refer to DTC Check / Clear. Chassis > EMPS > Trouble Codes
|
NEXT | |
| |
| 4. |
PROBLEM SYMPTOM CONFIRMATION |
|
Result | Proceed to | |
Symptom does not occur. |
A | | Symptom occurs. |
B |
| B |
 | GO TO STEP 6 |
|
A | |
| |
|
NEXT | |
| |
| 6. |
CHECK CAN COMMUNICATION SYSTEM* | (a) Check for DTCs.
Click here 
|
Result | Proceed to | |
CAN communication system DTCs are not output. |
A | | CAN communication system DTCs are output. |
B |
HINT:
- If any CAN communication system DTCs are output, perform troubleshooting for the CAN communication system first.
- If communication to the rack and pinion power steering gear assembly
cannot be established through the Techstream, inspect terminals CANH and
CANL of the DLC3 and the rack and pinion power steering gear assembly,
and the IG circuit of the rack and pinion power steering gear assembly.
| B |
| PROCEED TO CAN COMMUNICATION SYSTEM |
|
A | |
| |
(a) Check for DTCs. Chassis > EMPS > Trouble Codes
HINT: Refer to Diagnostic Trouble Code Chart when any DTCs are output.
Click here
|
Result | Proceed to | |
DTCs are not output. |
A | | DTCs are output. |
B |
| B |
| GO TO STEP 10 |
|
A | |
| |
| 8. |
PROBLEM SYMPTOMS TABLE | (a) Refer to Problem Symptoms Table.
Click here
|
Result | Proceed to | |
Fault is not listed in Problem Symptoms Table. |
A | | Fault is listed in Problem Symptoms Table. |
B |
| B |
| GO TO STEP 10 |
|
A | |
| |
| 9. |
OVERALL ANALYSIS AND TROUBLESHOOTING* |
(a) Refer to Terminals of ECU. Click here
(b) Refer to Data List / Active Test.
Click here
|
NEXT | |
| |
|
NEXT | |
| |
| NEXT |
| END | | 
