INSPECTION PROCEDURE 1. INSPECT TIRES
(a) Inspect the tires for wear and proper inflation pressure. Cold Tire Inflation Pressure: |
Tire Size | Cold Tire Inflation Pressure | |
Front | Rear | |
215/55R17 94V 235/45R18 94V 235/40R19 92V |
240 kPa (2.4 kgf/cm2, 35 psi) |
240 kPa (2.4 kgf/cm2, 35 psi) | Cold Tire Inflation Pressure (for Compact Spare Tire): |
Tire Size | Cold Tire Inflation Pressure | |
T155/70D17 110M | 420 kPa (4.2 kgf/cm2, 60 psi) |
(1) Perform initialization. for Gasoline Model: Click here
 for HV Model: Click here
(2) Tire pressure adjustment method when warm:
- Turn the engine switch (for Gasoline Model) or power switch (for HV Model) off.
- Connect the Techstream to the DLC3.
- Turn the engine switch (for Gasoline Model) or power switch (for HV Model) on (IG).
- Turn the Techstream on.
- Enter the following menus: Chassis / Tire Pressure Monitor / Data List.
- Adjust the tire pressure so that the displayed value is equal to the set pressure.
- Perform initialization and check that initialization completes.
for Gasoline Model: Click here
for HV Model: Click here
- Check and record the value of the Data List item "Temperature in Tire". (Ts)
- Check and record the ambient temperature during tire pressure adjustment. (Tm)
- Readjust the tire pressure according to the difference between the tire
internal temperature (Ts) and the ambient temperature (Tm). (P)
HINT:
Tire internal temperature: Ts, Ambient temperature: Tm, Tire pressure readjustment value: P
P = (Specified Pressure) + (Ts - Tm)
- Check the pressure adjustment value with the Data List item "Tire Inflation Pressure".
| (b) Using a dial indicator, check the runout of the tires.
Maximum Tire Runout: 1.4 mm (0.0551 in.) HINT: Measure the runout with the wheel assembly removed from the vehicle. |
|
2. ROTATE TIRES (a) Remove the wheel assembly. Click here
(b) Rotate the tires as shown in the illustration.
 |
Front | (c) Install the wheel assembly.
Click here (d) Perform initialization.
for Gasoline Model: Click here for HV Model: Click here
3. INSPECT AND ADJUST WHEEL BALANCE
| (a) Inspect and adjust the off-the-car balance. Maximum Wheel Imbalance:
8.0 g (0.0176 lb)
NOTICE:
- Use a cleaning detergent to remove dirt, oil and water from the surface where the balance weight is to be adhered.
- Do not touch the adhesive surface of the balance weight.
- Adhere a stick-on type balance weight to the flat surface*a shown in the illustration.
- Push the balance weight with your finger to securely adhere it to the desired position.
- Do not reuse balance weights.
- Use only TOYOTA genuine stick-on type balance weights or equivalent.
HINT:
- Use clip-on type balance weights for the inner side, and stick-on type balance weights for the outer side.
- If the tires vibrate even after the off-the-car balance adjustment,
adjust the wheel balance with on-the-car balancing as necessary.
| |
4. INSPECT FRONT AXLE HUB BEARING Click here
5. INSPECT REAR AXLE HUB BEARING Click here
| 
