DESCRIPTION This DTC is stored if the headlight ECU sub-assembly LH for another destination is installed.
CAUTION / NOTICE / HINT NOTICE:
PROCEDURE
(a) Connect the Techstream to the DLC3. (b) Turn the engine switch on (IG). (c) Turn the Techstream on. (d) Enter the following menus: Body Electrical / HL AutoLeveling / Trouble Codes. (e) Clear the DTCs. Body Electrical > HL AutoLeveling > Clear DTCs
(a) Connect the Techstream to the DLC3. (b) Turn the engine switch on (IG). (c) Turn the Techstream on. (d) Enter the following menus: Body Electrical / HL AutoLeveling / Trouble Codes. (e) Check for DTCs. Body Electrical > HL AutoLeveling > Trouble CodesOK: DTC B2456 is not output.
(a) Check if the part number of the ECM installed to the vehicle is correct. OK: Part number is correct.
(a) Check if the part number of the main body ECU (multiplex network body ECU) installed to the vehicle is correct. OK: Part number is correct.
|
Toyota Avalon (XX50) 2019-2022 Service & Repair Manual > Rear Seat Inner Belt Assembly(for Rh Side): Inspection
INSPECTION PROCEDURE 1. INSPECT REAR SEAT INNER WITH CENTER BELT ASSEMBLY RH (for Gasoline Model) (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition Specified Condition 5 - 4 Rear RH seat belt unfastened Below 1 Ω If the result ...