DESCRIPTION This DTC is stored if the headlight ECU sub-assembly LH for another destination is installed.
CAUTION / NOTICE / HINT NOTICE:
PROCEDURE
(a) Connect the Techstream to the DLC3. (b) Turn the power switch on (IG). (c) Turn the Techstream on. (d) Enter the following menus: Body Electrical / HL AutoLeveling / Trouble Codes. (e) Clear the DTCs. Body Electrical > HL AutoLeveling > Clear DTCs
(a) Connect the Techstream to the DLC3. (b) Turn the power switch on (IG). (c) Turn the Techstream on. (d) Enter the following menus: Body Electrical / HL AutoLeveling / Trouble Codes. (e) Check for DTCs. Body Electrical > HL AutoLeveling > Trouble CodesOK: DTC B2456 is not output.
(a) Check if the part number of the hybrid vehicle control ECU installed to the vehicle is correct. OK: Part number is correct.
(a) Check if the part number of the main body ECU (multiplex network body ECU) installed to the vehicle is correct. OK: Part number is correct.
|
Toyota Avalon (XX50) 2019-2022 Service & Repair Manual > Sfi System: Engine Coolant Pump Actuator Stuck (P26CB71)
DESCRIPTION Refer to DTC P26CA12. Click here DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory Note P26CB71 Engine Coolant Pump Actuator Stuck Even though an operation request signal is being output, the water inlet housing with water pump sub-assembly does not rotate* (1 trip d ...