INSTALLATION PROCEDURE 1. INSTALL STOP LIGHT SWITCH ASSEMBLY (a) Insert the stop light switch assembly until the threaded sleeve hits the pedal as shown in the illustration.
NOTICE: When inserting the stop light switch assembly, support the pedal from behind so that the pedal is not pushed in. (b) Turn the stop light switch assembly 1/4 clockwise as shown in the illustration to install it.
Torque: 1.5 N·m {15 kgf·cm, 13 in·lbf} or less NOTICE: When inserting the stop light switch assembly, support the pedal from behind so that the pedal is not pushed in. (c) Connect the connector. (d) Check the protrusion of the plunger. Protrusion of the Plunger
(e) If the protrusion is not as specified, recheck the stop light switch assembly installation and perform brake pedal adjustment if necessary. for Gasoline Model: Click here for HV Model: Click here NOTICE: Do not depress or support the brake pedal. 2. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Click here |
Toyota Avalon (XX50) 2019-2022 Service & Repair Manual > Navigation System(for Gasoline Model): Extension Module Malfunction 2 (B1556)
DESCRIPTION These DTCs are stored when a malfunction occurs in the Navigation ECU. DTC No. Detection Item DTC Detection Condition Trouble Area B1556 Extension Module Malfunction 2 When any of the following conditions is met: Internal power supply malfunction Internal hard drive malfunction EEPROM er ...