INSTALLATION CAUTION / NOTICE / HINT HINT:
PROCEDURE 1. INSTALL OUTER REAR VIEW MIRROR ASSEMBLY WITH COVER (a) Engage the 2 guides and claw. (b) Install the outer rear view mirror assembly with cover with the 3 nuts. Torque: 8.0 N·m {82 kgf·cm, 71 in·lbf} (c) Engage the clamp. 2. INSTALL OUTER MIRROR INSTALL HOLE COVER (a) Engage the clip and 2 claws. (b) Install the outer mirror install hole cover with the screw. (c) Engage the clamp. (d) Connect the connector. 3. INSTALL HOLE PLUG (a) Install the hole plug. 4. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY Click here 5. INSTALL COURTESY LIGHT ASSEMBLY Click here 6. INSTALL MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Driver Side) Click here 7. INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Front Passenger Side) Click here 8. INSTALL FRONT DOOR TRIM POCKET COVER Click here 9. INSTALL FRONT DOOR ARMREST COVER SUB-ASSEMBLY Click here 10. PERFORM CALIBRATION (w/ Panoramic View Monitor System) for Gasoline Model: Click here for HV Model: Click here |
Toyota Avalon (XX50) 2019-2022 Service & Repair Manual > Compressor(for A25a-fxs): Installation
INSTALLATION PROCEDURE 1. ADJUST COMPRESSOR OIL (a) When replacing the compressor with motor assembly with a new one, gradually discharge the inert gas from the service valve, and drain the following amount of oil from the new compressor with motor assembly before installation. Standard: (Oil capaci ...