Toyota Avalon (XX50) 2019-2022 Service & Repair Manual: Data List / Active Test

Toyota Avalon (XX50) 2019-2022 Service & Repair Manual / Vehicle Exterior / Sliding Roof / Convertible / Sliding Roof System(for Gasoline Model) / Data List / Active Test

DATA LIST / ACTIVE TEST

DATA LIST

HINT:

Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

NOTICE:

In the following table, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

(a) Connect the Techstream to the DLC3.

(b) Turn the engine switch on (IG).

(d) Enter the following menus: Body Electrical / Sliding Roof or Main Body / Data List.

(e) Read the Data List according to the display on the Techstream.

Body Electrical > Sliding Roof > Data List

Tester Display	Measurement Item	Range	Normal Condition	Diagnostic Note
Open Switch	OPEN switch signal	OFF or ON	OFF: OPEN switch not pressed ON: OPEN switch pressed	-
Close Switch	CLOSE switch signal	OFF or ON	OFF: CLOSE switch not pressed ON: CLOSE switch pressed	-
Up Switch	UP switch signal	OFF or ON	OFF: UP switch not pressed ON: UP switch pressed	-
Down Switch	DOWN switch signal	OFF or ON	OFF: DOWN switch not pressed ON: DOWN switch pressed	-
Front SW Auto Operation	Sliding roof auto operation function	OFF or ON	Customize setting displayed	-
Hall IC1 Pulse	Hall IC1 pulse output	Lo or Hi	Lo and Hi repeat during motor operation	Lo: Hall IC1 output is low Hi: Hall IC1 output is high
Hall IC1 Status	Status of Hall IC1	Normal or Error	Normal: Hall IC1 normal Error: Hall IC1 not normal	-
Hall IC2 Pulse	Hall IC2 pulse output	Lo or Hi	Lo and Hi repeat during motor operation	Lo: Hall IC2 output is low Hi: Hall IC2 output is high
Hall IC2 Status	Status of Hall IC2	Normal or Error	Normal: Hall IC2 normal Error: Hall IC2 not normal	-
Ignition (Direct Signal)	Engine switch signal	OFF or ON	OFF: Engine switch off ON: Engine switch on (IG)	-
Ignition (MPX)	Engine switch signal (LIN signal)	OFF or ON	OFF: Engine switch off ON: Engine switch on (IG)	-
Door Courtesy	Driver door courtesy light switch signal	OFF or ON	OFF: Driver door closed ON: Driver door open	-
Door Key Close Operation	Key-linked sliding roof close signal	OFF or ON	OFF: Driver door key cylinder not turned ON: Driver door key cylinder turned and held at the lock position	-
Door Key Open Operation	Key-linked sliding roof open signal	OFF or ON	OFF: Driver door key cylinder not turned ON: Driver door key cylinder turned and held at the unlock position	-
Wireless Open Operation	Wireless transmitter-linked sliding roof open signal	OFF or ON	OFF: Electrical key transmitter sub-assembly UNLOCK switch not pressed ON: Electrical key transmitter sub-assembly UNLOCK switch pressed and held	-
Key Off Permission	Key-off sliding roof operation permit signal	OFF or ON	OFF: Any status except "ON" status ON: Front doors are not opened within 45 seconds after engine switch turned off	-
Door Key Related Operation	Key-linked sliding roof open function operating direction	Slide or Tilt	Customize setting displayed	-
Wireless Key Rel Operation	Wireless transmitter-linked sliding roof open function operating direction	Slide or Tilt	Customize setting displayed	-
Open Switch Failure(Past)	Open switch failure signal (Past)	OFF or ON	OFF: No sliding roof open switch failure signal (Past) ON: Sliding roof open switch failure signal (Past)	-
Close Switch Failure(Past)	Close switch failure signal (Past)	OFF or ON	OFF: No sliding roof close switch failure signal (Past) ON: Sliding roof close switch failure signal (Past)	-
Up Switch Failure(Past)	Up switch failure signal (Past)	OFF or ON	OFF: No sliding roof tilt up switch failure signal (Past) ON: Sliding roof tilt up switch failure signal (Past)	-
Down Switch Failure(Past)	Down switch failure signal (Past)	OFF or ON	OFF: No sliding roof tilt down switch failure signal (Past) ON: Sliding roof tilt down switch failure signal (Past)	-
Open Switch Failure(Current)	Open switch failure signal (Current)	OFF or ON	OFF: No sliding roof open switch failure signal (Current) ON: Sliding roof open switch failure signal (Current)	-
Close Switch Failure(Current)	Close switch failure signal (Current)	OFF or ON	OFF: No sliding roof close switch failure signal (Current) ON: Sliding roof close switch failure signal (Current)	-
Up Switch Failure(Current)	Up switch failure signal (Current)	OFF or ON	OFF: No sliding roof tilt up switch failure signal (Current) ON: Sliding roof tilt up switch failure signal (Current)	-
Down Switch Failure(Current)	Down switch failure signal (Current)	OFF or ON	OFF: No sliding roof tilt down switch failure signal (Current) ON: Sliding roof tilt down switch failure signal (Current)	-
Suggestion Service Function	Availability of suggestion function	OFF or ON	OFF: w/o Suggestion function ON: w/ Suggestion function	-
Number of Trouble Codes	Number of DTCs	Min.: 0, Max.: 255	Number of stored DTCs	-

Body Electrical > Main Body > Data List

Tester Display	Measurement Item	Range	Normal Condition	Diagnostic Note
IG SW	Engine switch status	OFF or ON	OFF: Engine switch off ON: Engine switch on (IG)	"OFF" is displayed even though the engine switch is on (ACC).
FR Door Courtesy SW	Front door courtesy light switch assembly (for RH) signal	OFF or ON	OFF: Front door RH closed ON: Front door RH open	-
FL Door Courtesy SW	Front door courtesy light switch assembly (for LH) signal	OFF or ON	OFF: Front door LH closed ON: Front door LH open	-
Door Key P/W Up	Key-linked sliding roof close function	OFF or ON	Customize setting displayed	-
Door Key P/W Down	Key-linked sliding roof open function	OFF or ON	Customize setting displayed	-
P/W Down W/ Transmit	Wireless transmitter linked sliding roof open function	OFF or ON	Customize setting displayed	-
Slide Roof Open Warning	Sliding roof open warning function	OFF or ON	Customize setting displayed	-
Communication Slide Roof	Connection status between sliding roof ECU (sliding roof drive gear assembly) and main body ECU (multiplex network body ECU)	STOP or OK	STOP: Communication stopped OK: Normal communication	-

ACTIVE TEST

HINT:

Using the Techstream to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

(a) Connect the Techstream to the DLC3.

(b) Turn the engine switch on (IG).

(d) Enter the following menus: Body Electrical / Sliding Roof / Active Test.

(e) Perform the Active Test according to the display on the Techstream.

Body Electrical > Sliding Roof > Active Test

Tester Display	Measurement Item	Control Range	Diagnostic Note
Slide Roof	Operate sliding roof motor	OFF / Opn/Dwn / Clos/Up	-

Customize Parameters

Diagnosis System

See More:

Toyota Avalon (XX50) 2019-2022 Service & Repair Manual > Tire Pressure Warning System(for Hv Model): Transmitter ID not Registered (Main) (C2171)
DESCRIPTION The IDs of each tire pressure warning valve and transmitter are registered to the tire pressure warning ECU and receiver. When the ECU detects that a transmitter ID code is not registered in the ECU, this DTC is stored. DTC No. Detection Item DTC Detection Condition Trouble Area Note C21 ...

Toyota Avalon (XX50) 2019-2022 Service & Repair Manual: Data List / Active Test

Customize Parameters

Diagnosis System

See More:

Toyota Avalon (XX50) 2019-2022 Owners Manual

Toyota Avalon (XX50) 2019-2022 Service & Repair Manual