Toyota Avalon (XX50) 2019-2022 Service & Repair Manual: Speaker Circuit (B1350)

DESCRIPTION

The vehicle approaching speaker assembly circuit consists of the vehicle approaching speaker controller and vehicle approaching speaker assembly.

This DTC is stored when a malfunction is detected in the vehicle approaching speaker assembly circuit.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

B1350

Speaker Circuit

Either of the following conditions is met:

  • When sound output voltage is being monitored by the ECU, with the power switch on (IG), auxiliary battery voltage 10 V or more, and warning sound being produced, a speaker circuit short condition continues for 1 second or more.
  • When sound output voltage is being monitored by the ECU, with the power switch on (IG) and warning sound not being produced, a speaker circuit open condition continues for 5 seconds or more.
  • Vehicle approaching speaker controller
  • Vehicle approaching speaker assembly
  • Harness or connector

WIRING DIAGRAM

PROCEDURE

1.

INSPECT VEHICLE APPROACHING SPEAKER ASSEMBLY

(a) Remove the vehicle approaching speaker assembly.

Click here

(b) Inspect the vehicle approaching speaker assembly.

Click here

NG

REPLACE VEHICLE APPROACHING SPEAKER ASSEMBLY

OK

2.

CHECK HARNESS AND CONNECTOR (VEHICLE APPROACHING SPEAKER ASSEMBLY - VEHICLE APPROACHING SPEAKER CONTROLLER)

(a) Disconnect the G38 vehicle approaching speaker controller connector.

(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

A7-1 (+) - G38-3 (SP+)

Always

Below 1 Ω

A7-2 (-) - G38-8 (SP-)

Always

Below 1 Ω

A7-1 (+) or G38-3 (SP+) - Body ground

Always

10 kΩ or higher

A7-2 (-) or G38-8 (SP-) - Body ground

Always

10 kΩ or higher

OK

REPLACE VEHICLE APPROACHING SPEAKER CONTROLLER

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

    Vehicle Proximity Notification System

    Customize Parameters

    See More:

    Toyota Avalon (XX50) 2019-2022 Service & Repair Manual > Tilt And Telescopic Manual Switch: Inspection
    INSPECTION PROCEDURE 1. INSPECT TILT AND TELESCOPIC SWITCH (a) Remove the tilt and telescopic switch. Click here (b) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition Specified Condition G30-1 (VC) - G30-3 (MSW) Tilt up 342 to 378 Î ...

    Toyota Avalon (XX50) 2019-2022 Owners Manual

    Toyota Avalon (XX50) 2019-2022 Service & Repair Manual

    © 2024 Copyright www.tavalon.net
    0.0117