DESCRIPTION The condition of the windshield wiper switch assembly is detected and sent to the steering sensor in this circuit. WIRING DIAGRAM
 PROCEDURE
| 1. |
READ VALUE USING TECHSTREAM | (a) Connect the Techstream to the DLC3.
(b) Turn the engine switch on (IG). (c) Turn the Techstream on.
(d) Enter the following menus: Chassis / Steering Angle Sensor / Data List.
(e) Read the Data List according to the display on the Techstream. Chassis > Steering Angle Sensor > Data List
|
Tester Display | Measurement Item |
Range | Normal Condition |
Diagnostic Note | |
Wiper OFF Switch | Front wiper switch OFF position signal |
OFF or ON | OFF: Front wiper switch not in OFF position
ON: Front wiper switch in OFF position |
- | | Wiper Auto/Int Switch |
Front wiper switch INT position signal |
OFF or ON | OFF: Front wiper switch not in INT position
ON: Front wiper switch in INT position |
- | | Wiper Lo Switch |
Front wiper switch LO position signal |
OFF or ON | OFF: Front wiper switch not in LO position
ON: Front wiper switch in LO position |
- | | Wiper Hi Switch |
Front wiper switch HI position signal |
OFF or ON | OFF: Front wiper switch not in HI position
ON: Front wiper switch in HI position |
- | | Wiper Mist Switch |
Front wiper switch MIST position signal |
OFF or ON | OFF: Front wiper switch not in MIST position
ON: Front wiper switch in MIST position |
- | | Washer Switch |
Washer switch ON position signal |
OFF or ON | OFF: Front washer switch not in ON position
ON: Front washer switch in ON position |
- | | Intermittent Time Volume |
Intermittent time adjustment switch condition |
Shortest, Shorter, Longer, Longest |
Shortest: P4 Shorter: P3 Longer: P2 Longest: P1 |
* |
- *: Refer to Inspection for each position of the switch.
Click here 
Chassis > Steering Angle Sensor > Data List
|
Tester Display | | Wiper OFF Switch | |
Wiper Auto/Int Switch | |
Wiper Lo Switch | |
Wiper Hi Switch | |
Wiper Mist Switch | |
Washer Switch | |
Intermittent Time Volume | OK:
The Techstream display changes correctly in response to the windshield wiper switch assembly operation.
| OK |
 | PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE |
|
NG |
 | |
| 2. |
INSPECT WINDSHIELD WIPER SWITCH ASSEMBLY |
(a) Remove the windshield wiper switch assembly. Click here
(b) Inspect the windshield wiper switch assembly.
Click here
| NG |
| REPLACE WINDSHIELD WIPER SWITCH ASSEMBLY |
|
OK | |
| |
| 3. |
INSPECT STEERING WHEEL SWITCH HOUSING |
(a) Remove the steering wheel switch housing. Click here
(b) Inspect the steering wheel switch housing.
Click here
| OK |
| REPLACE STEERING SENSOR |
| NG |
| REPLACE STEERING WHEEL SWITCH HOUSING | | 
