Toyota Avalon (XX50) 2019-2022 Service & Repair Manual: Removal

REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during thermistor assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced

Replaced Part or Performed Procedure

Necessary Procedure

Effect/Inoperative Function when Necessary Procedure not Performed

Link

*: Applies only for when removing and installing or replacing the television camera assembly.

Front television camera assembly, front bumper assembly or radiator grille

  • Television camera view adjustment
  • Television camera assembly optical axis adjustment (Back camera position setting)*

Panoramic View Monitor System

for Initialization

for Calibration

Front bumper assembly

  • Measurement of ultrasonic sensor detection angle
  • Ultrasonic sensor detection angle registration
  • Intelligent Clearance Sonar System
  • Intuitive Parking Assist System

PROCEDURE

1. REMOVE FRONT BUMPER ASSEMBLY

Click here

2. REMOVE FRONT RADIATOR SIDE AIR GUIDE PLATE LH

(a) Disengage the 2 claws to remove the front radiator side air guide plate LH.

3. REMOVE THERMISTOR ASSEMBLY

(a) Disengage the clamp.

(b) Disconnect the connector to remove the thermistor assembly.

    Installation

    Blower Unit

    See More:

    Toyota Avalon (XX50) 2019-2022 Service & Repair Manual > Pre-collision System(for Hv Model): Dtc Check / Clear
    DTC CHECK / CLEAR CHECK DTC (a) Connect the Techstream to the DLC3. (b) Turn the power switch on (IG). (c) Turn the Techstream on. (d) Enter the following menus: Body Electrical / Pre-Collision 2 / Trouble Codes. (e) Check for DTCs. Click here Body Electrical > Pre-Collision 2 > Trouble Codes ...

    Toyota Avalon (XX50) 2019-2022 Owners Manual

    Toyota Avalon (XX50) 2019-2022 Service & Repair Manual

    © 2024 Copyright www.tavalon.net
    0.0226