REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during combination meter assembly removal/installation are shown below. Necessary Procedure After Parts Removed/Installed/Replaced (for Gasoline Model)
PROCEDURE 1. PRECAUTION NOTICE: After turning the engine switch (for Gasoline Model) or power switch (for HV Model) off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work. Click here
2. CHANGE POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM SETTINGS (for Power Tilt and Power Telescopic Steering Column) Click here 3. REMOVE LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY Click here 4. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL LH Click here 5. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL RH Click here 6. REMOVE FRONT CONSOLE UPPER PANEL GARNISH Click here 7. REMOVE CONSOLE BOX POCKET SUB-ASSEMBLY Click here 8. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY Click here 9. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY Click here 10. REMOVE REAR UPPER CONSOLE PANEL SUB-ASSEMBLY Click here 11. REMOVE CONSOLE BOX BEZEL Click here 12. REMOVE CENTER NO. 1 INSTRUMENT CLUSTER FINISH PANEL Click here 13. REMOVE CENTER NO. 2 INSTRUMENT CLUSTER FINISH PANEL Click here 14. REMOVE RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKET Click here 15. REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY Click here 16. REMOVE LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL Click here 17. REMOVE LOWER CENTER INSTRUMENT PANEL FINISH PANEL Click here 18. REMOVE INSTRUMENT CLUSTER FINISH PANEL GARNISH ASSEMBLY Click here 19. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY Click here 20. REMOVE NO. 1 INSTRUMENT PANEL GARNISH SUB-ASSEMBLY Click here 21. REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY Click here 22. REMOVE COMBINATION METER ASSEMBLY
(b) Disengage the 2 clips as shown in the illustration. 
(d) Disconnect the 2 connectors to remove the combination meter assembly. | ||||||||||||||||||||||||||||||||||||||||||||||||
Toyota Avalon (XX50) 2019-2022 Service & Repair Manual > Wiper And Washer System(for Hv Model): Precaution
PRECAUTION PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL NOTICE: When disconnecting the cable from the negative (-) auxiliary battery terminal, initialize the following systems after the cable is reconnected. System Name See Procedure Lane Departure Alert System (w/ Ste ...
