DESCRIPTION The combination
meter assembly and radio and display receiver assembly communicate via
local bus communication. This allows audio and visual system information
to be displayed on the multi-information display. This
DTC is stored when a communication error occurs between the radio and
display receiver assembly and combination meter assembly. |
DTC No. | Detection Item |
DTC Detection Condition | Trouble Area |
Memory | Note | |
B132187 | Lost Communication with EMV Missing Message |
Diagnosis Condition:
- The engine switch is on (IG)
- IG power source voltage is 9.5 V or more
Malfunction Status:
- No communication with radio and display receiver assembly
Malfunction Time:
|
- Harness or connector
- Radio and display receiver assembly
- Meter mirror sub-assembly*
- Combination meter assembly
| DTC stored |
- |
- *: w/ Headup Display System
WIRING DIAGRAM
 CAUTION / NOTICE / HINT
NOTICE: When
replacing the combination meter assembly, always replace it with a new
one. If a combination meter assembly which was installed to another
vehicle is used, the information stored in it will not match the
information from the vehicle and a DTC may be stored. PROCEDURE
(a) Choose the model to be inspected.
|
Result | Proceed to | |
w/o Headup Display System |
A | | w/ Headup Display System |
B |
| B |
 | GO TO STEP 4 |
|
A |
 | |
| 2. |
CHECK FOR DTC (AUDIO AND VISUAL SYSTEM) |
(a) Check if audio and visual system DTCs are output. Body Electrical > Navigation System > Trouble Codes
|
Result | Proceed to | |
DTCs are not output | A | |
DTCs are output | B |
| B |
| GO TO AUDIO AND VISUAL SYSTEM |
|
A | |
| |
| 3. |
REPLACE COMBINATION METER ASSEMBLY | (a) Replace the combination meter assembly with a new one.
Click here  (b) Turn the engine switch on (IG) and wait 30 seconds.
NOTICE: A
minimum of 30 seconds is required to send/receive the registration
information between the combination meter assembly and radio and display
receiver assembly. (c) Operate the steering pad switch assembly and check that the audio tab illuminates.
(d) Check if meter / gauge system DTCs are output. Body Electrical > Combination Meter > Trouble Codes
|
Result | Proceed to | |
The audio tab illuminates and DTC B132187 is not output |
A | | The audio tab does not illuminate and DTC B132187 is output |
B |
| A |
| END (COMBINATION METER ASSEMBLY WAS DEFECTIVE) |
| B |
| REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY |
| 4. |
CHECK FOR DTC (NAVIGATION SYSTEM) | (a) Check if navigation system DTCs are output. Body Electrical > Navigation System > Trouble Codes
|
Result | Proceed to | |
DTCs are not output | A | |
DTCs are output | B |
| B |
| GO TO NAVIGATION SYSTEM |
|
A | |
| |
| 5. |
CHECK FOR DTC (HEADUP DISPLAY SYSTEM) |
(a) Check if headup display system DTCs are output. Body Electrical > Head Up Display > Trouble Codes
|
Result | Proceed to | |
DTC B132187 is not output |
A | | DTC B132187 is output |
B |
| A |
| REPLACE COMBINATION METER ASSEMBLY |
| B |
| REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY | | 
