Toyota Avalon (XX50) 2019-2022 Service & Repair Manual: Vehicle Proximity Notification System Warning Message Display Malfunction

Toyota Avalon (XX50) 2019-2022 Service & Repair Manual / Vehicle Interior / Meter / Gauge / Display / Meter / Gauge System(for Hv Model) / Vehicle Proximity Notification System Warning Message Display Malfunction

DESCRIPTION

The combination meter assembly and vehicle approaching speaker controller are connected via direct line. If a malfunction occurs in the vehicle proximity notification system, the combination meter assembly receives a malfunction signal from the vehicle approaching speaker controller and outputs a warning.

WIRING DIAGRAM

CAUTION / NOTICE / HINT

NOTICE:

  • When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.
  • The following troubleshooting procedure is based on the assumption that the vehicle proximity notification system is normal. Confirm that the vehicle proximity notification system is not malfunctioning before performing the following procedure.

    Click here

PROCEDURE

1.

INSPECT COMBINATION METER ASSEMBLY (OUTPUT VOLTAGE)

*a

Front view of wire harness connector

(to Vehicle Approaching Speaker Controller)

(a) Disconnect the G38 vehicle approaching speaker controller connector.

(b) Measure the voltage according to the value(s) in the table below.

Standard Voltage:

Tester Connection

Condition

Specified Condition

G38-10 (IND) - Body ground

Power switch on (IG)

11 to 14 V
NG

GO TO STEP 3

OK

2.

INSPECT COMBINATION METER ASSEMBLY (WARNING MESSAGE)

*a

Front view of wire harness connector

(to Vehicle Approaching Speaker Controller)

(a) Turn the power switch off.

(b) Connect SST to terminal G38-10 (IND) and body ground.

SST: 09843-18040

(c) Turn the power switch on (IG).

(d) Check the combination meter assembly display.

Result

Proceed to

"Proximity Notification System Malfunction Visit Your Dealer" displayed on multi-information display

A

"Proximity Notification System Malfunction Visit Your Dealer" not displayed on multi-information display

B
A

REPLACE VEHICLE APPROACHING SPEAKER CONTROLLER

B

REPLACE COMBINATION METER ASSEMBLY

3.

CHECK HARNESS AND CONNECTOR (VEHICLE APPROACHING SPEAKER CONTROLLER - COMBINATION METER ASSEMBLY)

(a) Disconnect the G16 combination meter assembly connector.

(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

G38-10 (IND) - G16-8 (IND)

Always

Below 1 Ω

G38-10 (IND) or G16-8 (IND) - Body ground

Always

10 kΩ or higher
OK

REPLACE COMBINATION METER ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR
    Lost Communication With ECM/PCM "A" Missing Message (U010087,...,U113387)

    Trip Switch

    See More:

    Toyota Avalon (XX50) 2019-2022 Service & Repair Manual > Black Out Tape(for Front Door): Installation
    INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The following procedure is for the LH side. PROCEDURE 1. PRECAUTION NOTICE: After turning the engine switch (for Gasoline Model) or power switch (for HV Model) off, waiting time may be required before disc ...

    Toyota Avalon (XX50) 2019-2022 Owners Manual

    Toyota Avalon (XX50) 2019-2022 Service & Repair Manual

    © 2025 Copyright www.tavalon.net
    0.0328