DESCRIPTION The seat belt warning light on the combination meter assembly illuminates, blinks or turns off in accordance with the state of the front seat inner belt assembly LH. WIRING DIAGRAM  CAUTION / NOTICE / HINT NOTICE: The seat belt warning system uses the CAN communication system. First, confirm that there are no malfunctions in the CAN communication system. Refer to How to Proceed with Troubleshooting. Click here
HINT: The seat belt warning light on the combination meter assembly is used for both the driver seat and front passenger seat. Check that the operation of the seat belt warning light is normal first. Click here
If the seat belt warning light does not operate for both the driver seat and front passenger seat, replace the combination meter assembly. Click here
PROCEDURE
(a) Clear the DTCs. Body Electrical > SRS Airbag > Clear DTCs(b) Check for DTCs. Body Electrical > SRS Airbag > Trouble Codes
(a) Connect the Techstream to the DLC3. (b) Turn the engine switch on (IG). (c) Turn the Techstream on. (d) Enter the following menus: Body Electrical / SRS Airbag / Data List. (e) Read the Data List according to the display on the Techstream. Body Electrical > SRS Airbag > Data List
|
Toyota Avalon (XX50) 2019-2022 Service & Repair Manual > Rear Seat Inner Belt Assembly(for Lh Side): Installation
INSTALLATION PROCEDURE 1. INSTALL REAR SEAT INNER BELT ASSEMBLY LH (a) Install the rear seat inner with center belt assembly LH with the bolt. Torque: 42 N·m {428 kgf·cm, 31 ft·lbf} NOTICE: Do not allow the anchor part of the rear seat inner with center belt assembly LH to overlap the protruding ...
