CAUTION / NOTICE / HINT
HINT:
- Use the following procedure to troubleshoot the seat belt warning system.
- *: Use the Techstream.
PROCEDURE |
1. | VEHICLE BROUGHT TO WORKSHOP |
|
NEXT |
 | |
| 2. |
CUSTOMER PROBLEM ANALYSIS | (a) Interview the customer to confirm the problem.
Click here 
|
NEXT | |
| |
(a) Measure the auxiliary battery voltage with the power switch off.
Standard Voltage: 11 to 14 V If the voltage is below 11 V, recharge or replace the auxiliary battery before proceeding to the next step.
(b) Check the fuses and relays. (c)
Check the connector connections and terminals to make sure that there
are no abnormalities such as loose connections, deformation, etc.
|
NEXT | |
| |
| 4. |
CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM* |
(a) Using the Techstream, check for CAN communication system DTCs. Click here
|
Result | Proceed to | |
CAN DTCs are not output |
A | | CAN DTCs are output |
B |
| B |
 | GO TO CAN COMMUNICATION SYSTEM |
|
A | |
| |
| 5. |
CHECK DTC OUTPUT (AIRBAG SYSTEM)* | (a) Clear the DTCs. Body Electrical > SRS Airbag > Clear DTCs
(b) Check for DTCs. Body Electrical > SRS Airbag > Trouble Codes
|
Result | Proceed to | |
DTCs are not output | A | |
DTCs are output | B |
| B |
| GO TO AIRBAG SYSTEM |
|
A | |
| |
| 6. |
CHECK DTC OUTPUT (OCCUPANT CLASSIFICATION SYSTEM)* |
(a) Clear the DTCs. Body Electrical > Occupant Detection > Clear DTCs
(b) Check for DTCs. Body Electrical > Occupant Detection > Trouble Codes
|
Result | Proceed to | |
DTCs are not output | A | |
DTCs are output | B |
| B |
| GO TO OCCUPANT CLASSIFICATION SYSTEM |
|
A | |
| |
| 7. |
CHECK COMBINATION METER ASSEMBLY | (a) Check the operation of the speedometer, shift indicator and brake warning light on the combination meter assembly.
OK: The speedometer, shift indicator and brake warning light on the combination meter assembly operate normally.
| NG |
| GO TO METER / GAUGE SYSTEM |
|
OK | |
| |
| 8. |
PROBLEM SYMPTOMS TABLE | (a) Refer to Problem Symptoms Table.
Click here
|
Result | Proceed to | |
Fault is not listed in Problem Symptoms Table |
A | | Fault is listed in Problem Symptoms Table |
B |
| B |
| GO TO STEP 10 |
|
A | |
| |
| 9. |
OVERALL ANALYSIS AND TROUBLESHOOTING* |
(a) Data List / Active Test Click here
(b) Terminals of ECU Click here
(c) On-vehicle Inspection Click here
|
NEXT | |
| |
|
NEXT | |
| |
| NEXT |
| END | | 
