REMOVAL CAUTION / NOTICE / HINT
The
necessary procedures (adjustment, calibration, initialization, or
registration) that must be performed after parts are removed and
installed, or replaced during front power seat switch
removal/installation are shown below. Necessary Procedures After Parts Removed/Installed/Replaced (for Gasoline Model) |
Replaced Part or Performed Procedure |
Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed |
Link | |
*: When performing learning using the Techstream.
Click here  | |
Disconnect cable from negative auxiliary battery terminal |
Perform steering sensor zero point calibration |
Lane departure alert system (w/ Steering Control) |
| |
Pre-collision system | |
Intelligent clearance sonar system* | |
Lighting system (for Gasoline Model with Cornering Light) | |
Memorize steering angle neutral point |
Parking assist monitor system |
| |
Panoramic view monitor system |
|
- Occupant detection ECU
- Front passenger seat
| Zero point calibration (Occupant classification system) |
- Occupant classification system
- Passenger airbag ON/OFF indicator
- Airbag system (Front passenger side)
- Seat belt warning system (Front passenger)
|
| Necessary Procedures After Parts Removed/Installed/Replaced (for HV Model) |
Replaced Part or Performed Procedure |
Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed |
Link | |
*: When performing learning using the Techstream.
Click here | |
Disconnect cable from negative auxiliary battery terminal |
Perform steering sensor zero point calibration |
Lane departure alert system (w/ Steering Control) |
| |
Pre-collision system | |
Intelligent clearance sonar system* | |
Lighting system (for HV Model with Cornering Light) | |
Memorize steering angle neutral point |
Parking assist monitor system |
| |
Panoramic view monitor system |
|
- Occupant detection ECU
- Front passenger seat
| Zero point calibration (Occupant classification system) |
- Occupant classification system
- Passenger airbag ON/OFF indicator
- Airbag system (Front passenger side)
- Seat belt warning system (Front passenger)
|
|
CAUTION:
HINT:
- Use the same procedure for the RH side and LH side.
- The following procedure is for the LH side.
PROCEDURE 1. REMOVE FRONT SEAT ASSEMBLY
Click here 2. DISCONNECT SEPARATE TYPE FRONT SEATBACK COVER
Click here 3. REMOVE FRONT SEAT FRONT CUSHION SHIELD
Click here 4. REMOVE FRONT SEAT CUSHION SHIELD
Click here 5. REMOVE SLIDE AND VERTICAL POWER SEAT SWITCH KNOB
Click here 6. REMOVE RECLINING POWER SEAT SWITCH KNOB
Click here 7. REMOVE FRONT POWER SEAT SWITCH
| (a) Remove the 3 screws and front power seat switch from the front seat cushion shield. |
| | 
