Toyota Avalon (XX50) 2019-2022 Service & Repair Manual: Installation

INSTALLATION

PROCEDURE

1. INSTALL LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY

(a) Check that the engine switch (for Gasoline Model) or power switch (for HV Model) is off.

(b) Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

(c) Connect the airbag connector to the lower No. 2 instrument panel airbag assembly.

*a

Airbag Connector

*b

Airbag Connector Locking Button

Push in this Direction

NOTICE:

When connecting any airbag connector, take care not to damage the airbag wire harness.

(d) Push in the airbag connector locking button to install the airbag connector.

(e) Engage the 3 claws to temporarily install the lower No. 2 instrument panel airbag assembly.

(f) Install the lower No. 2 instrument panel airbag assembly with the 3 bolts.

Torque:

10 N·m {102 kgf·cm, 7 ft·lbf}

NOTICE:

Confirm that the lower No. 2 instrument panel airbag assembly is installed securely without any excessive gaps and is not protruding outward.

2. INSTALL INSTRUMENT PANEL FINISH PANEL END LH

Click here

3. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Click here

4. INSTALL INSTRUMENT SIDE PANEL RH

Click here

5. INSTALL GLOVE COMPARTMENT PLATE

Click here

6. CONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP RH

7. INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH

HINT:

Use the same procedure as for the LH side.

Click here

8. INSTALL FRONT DOOR SCUFF PLATE RH

HINT:

Use the same procedure as for the LH side.

Click here

9. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

for Gasoline Model: Click here

for HV Model: Click here

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click here

10. INSTALL LUGGAGE TRIM SERVICE HOLE COVER (for HV Model)

Click here

11. PERFORM DIAGNOSTIC SYSTEM CHECK

for Gasoline Model: Click here

for HV Model: Click here

12. INSPECT SRS WARNING LIGHT

for Gasoline Model: Click here

for HV Model: Click here

    Disposal

    On-vehicle Inspection

    See More:

    Toyota Avalon (XX50) 2019-2022 Service & Repair Manual > Heated Oxygen Sensor: Removal
    REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during heated oxygen sensor removal/installation are shown below. Necessary Procedures After Parts Removed/Inst ...

    Toyota Avalon (XX50) 2019-2022 Owners Manual

    Toyota Avalon (XX50) 2019-2022 Service & Repair Manual

    © 2024 Copyright www.tavalon.net
    0.0342