Toyota Avalon (XX50) 2019-2022 Service & Repair Manual: Removal

Toyota Avalon (XX50) 2019-2022 Service & Repair Manual / Vehicle Interior / Supplemental Restraint Systems / Seat Position Sensor / Removal

REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during seat position airbag sensor removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced (for Gasoline Model)

Replaced Part or Performed Procedure	Necessary Procedure	Effect/Inoperative Function when Necessary Procedure not Performed
*: When performing learning using the Techstream. Click here
Disconnect cable from negative auxiliary battery terminal	Perform steering sensor zero point calibration	Lane Departure Alert System (w/ Steering Control)
		Pre-collision System
		Intelligent Clearance Sonar System*
		Lighting System (for Gasoline Model with Cornering Light)
	Memorize steering angle neutral point	Parking Assist Monitor System
	Memorize steering angle neutral point	Panoramic View Monitor System

Necessary Procedures After Parts Removed/Installed/Replaced (for HV Model)

Replaced Part or Performed Procedure	Necessary Procedure	Effect/Inoperative Function when Necessary Procedure not Performed
*: When performing learning using the Techstream. Click here
Disconnect cable from negative auxiliary battery terminal	Perform steering sensor zero point calibration	Lane Departure Alert System (w/ Steering Control)
		Pre-collision System
		Intelligent Clearance Sonar System*
		Lighting System (for HV Model with Cornering Light)
	Memorize steering angle neutral point	Parking Assist Monitor System
	Memorize steering angle neutral point	Panoramic View Monitor System

PROCEDURE

1. REMOVE FRONT SEAT ASSEMBLY LH

Click here

2. REMOVE POSITION CONTROL ECU ASSEMBLY (w/ Seat Position Memory System)

Click here

3. REMOVE SEAT POSITION AIRBAG SENSOR

(a) Disengage the clamp and disconnect the connector.

(b) Using a T30 "TORX" socket wrench, remove the "TORX" bolt and seat position airbag sensor with the seat slide position sensor protector.

(c) Disengage the pin to remove the seat position airbag sensor from the seat slide position sensor protector as shown in the illustration.

Remove in this Direction

On-vehicle Inspection

Side Airbag Sensor(for Center Pillar)

See More:

Toyota Avalon (XX50) 2019-2022 Service & Repair Manual > Headup Display System(for Gasoline Model): Terminals Of Ecu
TERMINALS OF ECU METER MIRROR SUB-ASSEMBLY (a) Measure the voltage and resistance according to the value(s) in the table below. Terminal No. (Symbol) Wiring Color Terminal Description Signal Input/Output Condition Specified Condition H1-1 (IG) - Body ground L - Body ground Engine switch signal - Eng ...

Toyota Avalon (XX50) 2019-2022 Service & Repair Manual: Removal

On-vehicle Inspection

Side Airbag Sensor(for Center Pillar)

See More:

Toyota Avalon (XX50) 2019-2022 Owners Manual

Toyota Avalon (XX50) 2019-2022 Service & Repair Manual