Toyota Avalon (XX50) 2019-2022 Service & Repair Manual: Engine Immobiliser System Incorrect Assembly (B279C95)

DESCRIPTION

If a hybrid vehicle control ECU that is incompatible with the immobiliser function is installed, the hybrid vehicle control ECU will store this DTC.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

Note

B279C95

Engine Immobiliser System Incorrect Assembly

A hybrid vehicle control ECU that is incompatible with the immobiliser function is installed. (1-trip detection logic*)

Hybrid vehicle control ECU

-

  • *: Only detected while a malfunction is present.
Vehicle Condition and Fail-safe Function when Malfunction Detected

Vehicle Condition when Malfunction Detected

Fail-safe Function when Malfunction Detected

Hybrid control system cannot be started

-

Related Data List and Active Test

DTC No.

Data List and Active Test

B279C95

-

CAUTION / NOTICE / HINT

NOTICE:

  • When using the Techstream with the power switch off, connect the Techstream to the DLC3 and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the Techstream and the vehicle begins. Then select the vehicle type under manual mode and enter the following menus: Body Electrical / Smart Key. While using the Techstream, periodically turn a courtesy light switch on and off at intervals of 1.5 seconds or less to maintain communication between the Techstream and the vehicle.
  • The smart key system (for Start Function, HV Model) uses the LIN communication system and CAN communication system. Inspect the communication function by following How to Proceed with Troubleshooting. Troubleshoot the smart key system (for Start Function, HV Model) after confirming that the communication systems are functioning properly.

    Click here

  • Before replacing the hybrid vehicle control ECU, refer to Registration.

    Click here

  • After performing repairs, confirm that no DTCs are output by performing "DTC Output Confirmation Operation".

PROCEDURE

1.

REPLACE HYBRID VEHICLE CONTROL ECU

(a) Temporarily replace the hybrid vehicle control ECU with a new one.

Click here

NEXT

END (HYBRID VEHICLE CONTROL ECU WAS DEFECTIVE)

    Engine Immobiliser System Circuit Short to Battery (B279A12)

    Ignition Hold Monitor Malfunction (B2271)

    See More:

    Toyota Avalon (XX50) 2019-2022 Service & Repair Manual > Steering Heater Switch: Installation
    INSTALLATION PROCEDURE 1. INSTALL STEERING HEATER SWITCH (a) Engage the 2 claws to install the steering heater switch. Install in this direction 2. INSTALL NO. 1 INSTRUMENT PANEL SUB-ASSEMBLY Click here 3. CONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY Click here 4. INSTALL NO. 1 INSTRUMENT PANEL UNDE ...

    Toyota Avalon (XX50) 2019-2022 Owners Manual

    Toyota Avalon (XX50) 2019-2022 Service & Repair Manual

    © 2024 Copyright www.tavalon.net
    0.0156