Toyota Avalon (XX50) 2019-2022 Service & Repair Manual: Does not Recognize Voice Commands Performed to Contact Support Center

PROCEDURE

1.

CHECK COMMUNICATION BASED VOICE RECOGNITION FUNCTION

(a) While paying attention to the condition of the spoken voice command, say "Find a gas station in New York" and check that voice recognition is operating normally.

HINT:

  • When the voice command is recognized, the content of the voice command is displayed in the voice recognition result display area to the right of the mic icon. (Example: When "Find a gas station in New York" is spoken, "Find a gas station in New York" is displayed in the voice recognition result display area.)
  • If an unnecessary word (such as "um" or "ah") is spoken before or after the recognition word, the system incorrectly recognizes the recognition word.
  • The system cannot recognize voice commands when multiple people are speaking simultaneously.
  • If the speaking speed is too fast or too slow, the recognition rate may decrease.
  • The system may have difficulty recognizing voice commands depending on the voice quality (such as a hoarse voice due to poor physical condition).

OK:

Voice command is recognized normally.

OK

END

NG

CONTACT SERVICE CENTER

    DCM Data Signal Circuit between Navigation ECU and DCM

    GPS Mark is not Displayed

    See More:

    Toyota Avalon (XX50) 2019-2022 Service & Repair Manual > Automatic Transaxle System: Pressure Control Solenoid "H" Circuit Short to Ground or Open (P281614)
    DESCRIPTION Refer to DTC P281612. Click here DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory Note P281614 Pressure Control Solenoid "H" Circuit Short to Ground or Open While the vehicle is being driven so that gear changes occur, a short to ground or open is detected in the so ...

    Toyota Avalon (XX50) 2019-2022 Owners Manual

    Toyota Avalon (XX50) 2019-2022 Service & Repair Manual

    © 2024 Copyright www.tavalon.net
    0.0401