Toyota Avalon (XX50) 2019-2022 Service & Repair Manual: XM Tuner Antenna Disconnected (B15FE,B15FF)

DESCRIPTION

These DTCs are stored when a malfunction occurs in the telephone antenna assembly which is connected to the radio and display receiver assembly.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

B15FE

XM Tuner Antenna Disconnected

The telephone antenna assembly is not connected

  • No. 4 antenna cord sub-assembly
  • No. 3 antenna cord sub-assembly
  • No. 2 antenna cord sub-assembly
  • Telephone antenna assembly
  • Radio and display receiver assembly

B15FF

XM Tuner Antenna Short

A short occurs in the telephone antenna assembly

  • No. 4 antenna cord sub-assembly
  • No. 3 antenna cord sub-assembly
  • No. 2 antenna cord sub-assembly
  • Telephone antenna assembly
  • Radio and display receiver assembly

CAUTION / NOTICE / HINT

NOTICE:

  • Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Navigation System.

    Click here

  • When replacing the radio and display receiver assembly, always replace it with a new one. If a radio and display receiver assembly which was installed to another vehicle is used, the following may occur:
    • A communication malfunction DTC may be stored.
    • The radio and display receiver assembly may not operate normally.

PROCEDURE

1.

REPLACE NO. 4 ANTENNA CORD SUB-ASSEMBLY

(a) Replace the No. 4 antenna cord sub-assembly with a new or known good one.

Click here

(b) Clear the DTCs.

Body Electrical > Navigation System > Clear DTCs

(c) Recheck for DTCs and check that no DTCs are output.

Body Electrical > Navigation System > Trouble Codes

OK:

No DTCs are output.

OK

END

NG

2.

REPLACE NO. 3 ANTENNA CORD SUB-ASSEMBLY

(a) Replace the No. 3 antenna cord sub-assembly with a new or known good one.

Click here

(b) Clear the DTCs.

Body Electrical > Navigation System > Clear DTCs

(c) Recheck for DTCs and check that no DTCs are output.

Body Electrical > Navigation System > Trouble Codes

OK:

No DTCs are output.

OK

END

NG

3.

REPLACE NO. 2 ANTENNA CORD SUB-ASSEMBLY

(a) Replace the No. 2 antenna cord sub-assembly with a new or known good one.

Click here

(b) Clear the DTCs.

Body Electrical > Navigation System > Clear DTCs

(c) Recheck for DTCs and check that no DTCs are output.

Body Electrical > Navigation System > Trouble Codes

OK:

No DTCs are output.

OK

END

NG

4.

REPLACE TELEPHONE ANTENNA ASSEMBLY

(a) Replace the telephone antenna assembly with a new or known good one.

Click here

(b) Clear the DTCs.

Body Electrical > Navigation System > Clear DTCs

(c) Recheck for DTCs and check that no DTCs are output.

Body Electrical > Navigation System > Trouble Codes

OK:

No DTCs are output.

OK

END

NG

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY

    D-Seat ECU Vehicle Information Reading/Writing Process Malfunction (B15F8)

    GVIF Disconnected (from Extension Module to H/U) (B153A)

    See More:

    Toyota Avalon (XX50) 2019-2022 Service & Repair Manual > Lane Departure Alert System (w/ Steering Control)(for Hv Model): Parts Location
    PARTS LOCATION ILLUSTRATION *1 FRONT SPEED SENSOR RH *2 FRONT SPEED SENSOR LH *3 REAR AXLE HUB AND BEARING ASSEMBLY RH - REAR SPEED SENSOR RH *4 REAR AXLE HUB AND BEARING ASSEMBLY LH - REAR SPEED SENSOR LH ILLUSTRATION *1 FORWARD RECOGNITION CAMERA *2 MILLIMETER WAVE RADAR SENSOR ASSEMBLY *3 BRAKE B ...

    Toyota Avalon (XX50) 2019-2022 Owners Manual

    Toyota Avalon (XX50) 2019-2022 Service & Repair Manual

    © 2024 Copyright www.tavalon.net
    0.0168