Toyota Avalon (XX50) 2019-2022 Service & Repair Manual: Blind Spot Monitor Slave Module (C1AB7)

Toyota Avalon (XX50) 2019-2022 Service & Repair Manual / Audio, Visual, Telematics / Park Assist / Monitoring / Blind Spot Monitor System(for Gasoline Model) / Blind Spot Monitor Slave Module (C1AB7)

DESCRIPTION

This DTC is stored when the blind spot monitor sensor LH detects an internal malfunction.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

C1AB7

Blind Spot Monitor Slave Module

The blind spot monitor sensor LH (slave) detects an internal malfunction

Blind spot monitor sensor LH

CAUTION / NOTICE / HINT

NOTICE:

When checking for DTCs, make sure that the blind spot monitor system is turned on.

PROCEDURE

1.

CHECK DTC

(a) Turn the engine switch off.

(b) Turn the engine switch on (IG).

(c) Recheck for DTCs and check if the same DTC is output again.

Body Electrical > Blind Spot Monitor Slave > Trouble Codes

OK:

No DTCs are output.

OK

USE SIMULATION METHOD TO CHECK

NG

REPLACE BLIND SPOT MONITOR SENSOR LH

    Blind Spot Monitor Master Module (C1AB6)

    Destination Information Undefined (C1AB8)

    See More:

    Toyota Avalon (XX50) 2019-2022 Service & Repair Manual > Active Control Engine Mount(for Rear Side): On-vehicle Inspection
    ON-VEHICLE INSPECTION CAUTION / NOTICE / HINT HINT: Refer to Problem Symptoms Table. Click here PROCEDURE 1. REMOVE FRONT WHEEL OPENING EXTENSION PAD LH Click here 2. REMOVE FRONT WHEEL OPENING EXTENSION PAD RH Click here 3. REMOVE NO. 1 ENGINE UNDER COVER Click here 4. REMOVE REAR ENGINE UNDER COVE ...

    Toyota Avalon (XX50) 2019-2022 Owners Manual

    Toyota Avalon (XX50) 2019-2022 Service & Repair Manual

    © 2024 Copyright www.tavalon.net
    0.0111