Toyota Avalon (XX50) 2019-2022 Service & Repair Manual: Software Incompatibility with Body Control Module "B" (U1331)

Toyota Avalon (XX50) 2019-2022 Service & Repair Manual / Audio, Visual, Telematics / Park Assist / Monitoring / Blind Spot Monitor System(for Gasoline Model) / Software Incompatibility with Body Control Module "B" (U1331)

DESCRIPTION

This DTC is stored when the destination information of the main body ECU (multiplex network body ECU) does not match that of the blind spot monitor sensors.

Blind Spot Monitor Master

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

U1331

Software Incompatibility with Body Control Module "B"

Destination information of the main body ECU and blind spot monitor sensor do not match
  • Main body ECU (multiplex network body ECU)
  • Blind spot monitor sensor RH
Blind Spot Monitor Slave

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

U1331

Software Incompatibility with Body Control Module "B"

Destination information of the main body ECU and blind spot monitor sensor do not match
  • Main body ECU (multiplex network body ECU)
  • Blind spot monitor sensor LH

CAUTION / NOTICE / HINT

NOTICE:

  • When checking for DTCs, make sure that the blind spot monitor system is on.
  • Before replacing the main body ECU (multiplex network body ECU), refer to Registration.

    w/ Smart Key System: Click here

PROCEDURE

1.

CONFIRM PART NUMBER (MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU))

(a) Check the main body ECU (multiplex network body ECU) part number.

(1) Check if the part number of the main body ECU (multiplex network body ECU) installed on the vehicle is correct.

OK:

The part number is correct.

NG

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)

OK

2.

CHECK DTC

(a) Clear the DTCs.

Body Electrical > Blind Spot Monitor Master > Clear DTCs Body Electrical > Blind Spot Monitor Slave > Clear DTCs

(b) Recheck for DTCs and check if the same DTC is output again.

Body Electrical > Blind Spot Monitor Master > Trouble Codes Body Electrical > Blind Spot Monitor Slave > Trouble Codes

Result

Proceed to

No DTCs are output

A

DTC U1331 is output ("Blind Spot Monitor Master")

B

DTC U1331 is output ("Blind Spot Monitor Slave")

C
A

USE SIMULATION METHOD TO CHECK

B

REPLACE BLIND SPOT MONITOR SENSOR RH

C

REPLACE BLIND SPOT MONITOR SENSOR LH

    Lost Communication with Blind Spot Monitor Master Module (U0233)

    Clearance Warning Buzzer(for Front)

    See More:

    Toyota Avalon (XX50) 2019-2022 Service & Repair Manual > Lane Departure Alert System (w/ Steering Control)(for Gasoline Model): Parts Location
    PARTS LOCATION ILLUSTRATION *1 FRONT SPEED SENSOR RH *2 FRONT SPEED SENSOR LH *3 REAR AXLE HUB AND BEARING ASSEMBLY RH - REAR SPEED SENSOR RH *4 REAR AXLE HUB AND BEARING ASSEMBLY LH - REAR SPEED SENSOR LH ILLUSTRATION *1 FORWARD RECOGNITION CAMERA *2 MILLIMETER WAVE RADAR SENSOR ASSEMBLY *3 BRAKE A ...

    Toyota Avalon (XX50) 2019-2022 Owners Manual

    Toyota Avalon (XX50) 2019-2022 Service & Repair Manual

    © 2024 Copyright www.tavalon.net
    0.0144