DESCRIPTION This DTC is
stored when the television camera assembly receives an RCTA buzzer
circuit malfunction signal from the blind spot monitor sensor RH. |
DTC No. | Detection Item |
DTC Detection Condition | Trouble Area |
DTC Output from | |
C2A5D | BSM Buzzer Malfunction |
The RCTA buzzer circuit is abnormal. |
- Blind spot monitor system
- Television camera assembly
| Television camera assembly | CAUTION / NOTICE / HINT
NOTICE:
- When "!" is displayed on the radio and display receiver assembly after
the cable is disconnected from the negative (-) battery terminal,
correct the steering angle neutral point.
Click here 
- Depending on the parts that are replaced or operations that are
performed during vehicle inspection or maintenance, calibration of other
systems as well as the panoramic view monitor system may be needed.
Click here
PROCEDURE |
1. | READ VALUE USING TECHSTREAM (BLIND SPOT MONITOR SENSOR LH STATUS) |
(a) Connect the Techstream to the DLC3. (b) Turn the engine switch on (IG).
(c) Turn the Techstream on. (d) Enter the following menus: Body Electrical / Blind Spot Monitor Slave / Data List.
(e) Read the Data List according to the display on the Techstream. Body Electrical > Blind Spot Monitor Slave > Data List
|
Tester Display | Measurement Item |
Range | Normal Condition |
Diagnostic Note | |
Buzzer Connection | Status of the buzzer connection |
Valid or Invalid | Valid: Buzzer connection is valid
Invalid: Buzzer connection is invalid |
- | | Slave Side RCTA Function |
Switches the RCTA function on and off |
OFF or ON | OFF: RCTA function off
ON: RCTA function on |
- | Body Electrical > Blind Spot Monitor Slave > Data List
|
Tester Display | | Buzzer Connection | |
Slave Side RCTA Function |
|
Result | Proceed to | |
"Valid" and "ON" is displayed for all items. |
A | | "Invalid" or "OFF" is displayed. |
B |
| B |
 | GO TO BLIND SPOT MONITOR SYSTEM (PROBLEM SYMPTOMS TABLE) |
|
A |
 | |
(a) Clear the DTCs. Chassis > Parking Assist Camera > Clear DTCs
(b) Recheck for DTCs and check that no DTCs are output. Chassis > Parking Assist Camera > Trouble Codes
|
Result | Proceed to | |
DTC C2A5D is output | A | |
DTC C2A5D is not output |
B |
| B |
| REPLACE TELEVISION CAMERA ASSEMBLY |
|
A | |
| |
| 3. |
CHECK FOR DTC (BLIND SPOT MONITOR SYSTEM (C1ABE)) |
(a) Check for DTCs. Body Electrical > Blind Spot Monitor Slave > Trouble Codes
|
Result | Proceed to | |
DTC C1ABE is output | A | |
DTC C1ABE is not output |
B |
| A |
| GO TO DIAGNOSTIC TROUBLE CODE CHART (C1ABE) |
| B |
| GO TO BLIND SPOT MONITOR SYSTEM (PROBLEM SYMPTOMS TABLE) | | 
