Symptom | Suspected Area |
Link |
Estimated course lines are not displayed |
Parking assist monitor screen display mode settings (Check that estimated course line display mode is selected) |
- |
Correct the steering angle neutral point (Initialization) |
|
Steering angle setting (Calibration) |
|
Television camera assembly |
|
Steering sensor |
|
Estimated course lines stop moving before the steering wheel is turned fully left. |
Steering angle setting (Calibration) |
|
The estimated course lines do not match the vehicle width extension lines when the steering wheel points straight ahead. |
Check the installation of steering wheel |
|
Correct the steering angle neutral point (Initialization) |
|
Steering angle setting (Calibration) |
|
Check that the television camera assembly is correctly installed |
|
Back camera position setting (Calibration) |
|
Television camera assembly |
|
Steering sensor |
|
The guide lines are not displayed even though the luggage compartment door is closed |
Check
that the No. 1 luggage compartment light assembly illuminates normally
(if not, refer to Lighting System (INT) - Problem Symptoms Table) |
|
Television camera assembly |
|
The guide lines remain displayed even though the luggage compartment door is open |
Check
that the No. 1 luggage compartment light assembly illuminates normally
(if not, refer to Lighting System (INT) - Problem Symptoms Table) |
|
Television camera assembly |
|
"!" mark is displayed. |
Correct the steering angle neutral point (Initialization) |
|
"!" mark remains displayed after the steering neutral point is corrected. |
Steering angle setting (Calibration) |
|
Steering sensor |
|
Television camera assembly |
|
When
adjusting the camera optical axis, "You can not calibrate the camera
when the door is open. Please close the door." is displayed even after
the has been closed | Check
that the No. 1 luggage compartment light assembly illuminates normally
(if not, refer to Lighting System (INT) - Problem Symptoms Table) |
|
Television camera assembly |
|
"CHK" message(s) are displayed on the signal check screen |
Signal check (Diagnosis system) |
|
When an image of the area behind the vehicle is displayed, the lines are misaligned (the image from the camera is tilted) |
Back camera position setting (Calibration) |
|