Displays suggestions to the driver in the following situations. To select
a response to a displayed suggestion, use the meter control switches.
The suggestion function can be turned on/off.
■ Suggestion to turn off the headlights
If the headlights are left on for a certain amount of time after the
engine switch has been turned off, if the headlight switch is in the
"AUTO" position, a suggestion message will be displayed asking if
you wish to turn the headlights off. To turn the headlights off, select
"Yes".
If a front door is opened after the engine switch is turned off, this suggestion
message will not be displayed.
■Eco Driving Indicator
- Eco Driving Indicator Light
During Eco-friendly acceleration (Eco
driving), the Eco Driving Indicator Light
will turn on. When the acceleration
exceeds the Zone of Eco driving, or
when the vehicle is stopped, the light
turns off.
- Eco Driving Indicator Zone Display
Suggests the Zone of Eco driving with
current Eco driving ratio based on
acceleration.
- Eco driving ratio based on acceleration
If the acceleration exceeds the Zone of
Eco driving, the right side of the Eco
Driving Indicator Zone Display will illuminate.
- Zone of Eco driving
Eco Driving Indicator will not operate under the following conditions:
- The shift lever is in any position other than D.
- A paddle shift switch (if equipped) is operated.
- Neither normal mode nor Eco drive mode is selected.
- The vehicle speed is approximately 80 mph (130 km/h) or higher.
■Suspension of the settings display
- Some settings cannot be changed while driving. When changing settings,
park the vehicle in a safe place.
- If a warning message is displayed, operation of the settings display
will be
suspended.
■Tire pressure
- It may take a few minutes to display the tire inflation pressure after
the
engine switch is turned to IGNITION ON mode. It may also take a few minutes
to display the tire inflation pressure after inflation pressure has been
adjusted.
- "---" may be displayed if the tire position information cannot be
determined
due to unfavorable radio wave conditions.
- Tire inflation pressure changes with temperature. The displayed values
may
also be different from the values measured using a tire pressure gauge.
■Liquid crystal display
Small spots or light spots may appear on the display. This phenomenon is
characteristic of liquid crystal displays, and there is no problem continuing to
use the display.
■Customization
Some functions can be customized.
| WARNING ■Caution for use while driving
- When operating the multi-information display while driving, pay
extra
attention to the safety of the area around the vehicle.
- Do not look continuously at the multi-information display while
driving as
you may fail to see pedestrians, objects on the road, etc. ahead of
the
vehicle.
■The information display at low temperatures
Allow the interior of the vehicle to warm up before using the liquid
crystal
information display. At extremely low temperatures, the information
display
monitor may respond slowly, and display changes may be delayed.
For example, there is a lag between the driver's shifting and the new
gear
number appearing on the display. This lag could cause the driver to
downshift
again, causing rapid and excessive engine braking and possibly an
accident resulting in death or injury.
■Cautions during setting up the display
As the engine needs to be running during setting up the display, ensure
that
the vehicle is parked in a place with adequate ventilation. In a closed
area
such as a garage, exhaust gases including harmful carbon monoxide (CO)
may collect and enter the vehicle. This may lead to death or a serious
health hazard. |
| NOTICE ■While setting up the display
To prevent battery discharge, ensure that the engine is running while
setting
up the display features. |
|
