DTC SUMMARY MALFUNCTION DESCRIPTION The main CPU and sub CPU of the Hybrid vehicle control ECU monitor each other.
The cause of this malfunction may be the following: Hybrid vehicle control ECU internal malfunction
- Hybrid vehicle control ECU malfunction
DESCRIPTION The
hybrid vehicle control ECU monitors its internal operation and will
store these DTCs when it detects an internal malfunction. |
DTC No. | Detection Item |
DTC Detection Condition | Trouble Area |
MIL | Warning Indicate | |
P060694 | Hybrid/EV Powertrain Control Module Processor Unexpected Operation |
The main CPU value received by the sub CPU of the hybrid vehicle control ECU exceeds the threshold for a certain period of time.
(1 trip detection logic) |
Hybrid vehicle control ECU |
Comes on | Master Warning Light:
Comes on | MONITOR DESCRIPTION
The
hybrid vehicle control ECU monitors its internal operation. If the
internal operation is malfunctioning, the hybrid vehicle control ECU
illuminates the MIL and stores a DTC. MONITOR STRATEGY |
Related DTCs | P0606 (INF P060694): Control module processor | |
Required sensors/components | Hybrid vehicle control ECU | |
Frequency of operation | Continuous | |
Duration | TMC's intellectual property | |
MIL operation | 1 driving cycle | |
Sequence of operation | None | TYPICAL ENABLING CONDITIONS |
The monitor will run whenever the following DTCs are not stored |
TMC's intellectual property | | Other conditions belong to TMC's intellectual property |
- | TYPICAL MALFUNCTION THRESHOLDS |
TMC's intellectual property | - | COMPONENT OPERATING RANGE |
Hybrid vehicle control ECU | DTC P0606 (INF P060694) is not detected | CONFIRMATION DRIVING PATTERN
HINT:
- After repair has been completed, clear the DTC and then check that the
vehicle has returned to normal by performing the following All Readiness
check procedure.
Click here 
- When clearing the permanent DTCs, refer to the "CLEAR PERMANENT DTC" procedure.
Click here
- Connect the Techstream to the DLC3.
- Turn the power switch on (IG) and turn the Techstream on.
- Clear the DTCs (even if no DTCs are stored, perform the clear DTC procedure).
- Turn the power switch off and wait for 2 minutes or more.
- Turn the power switch on (IG) and turn the Techstream on.
- Turn the power switch on (READY) and wait for 10 seconds or more. [*1]
HINT:
[*1] : Normal judgment procedure.
The normal judgment procedure is used to complete DTC judgment and also used when clearing permanent DTCs.
- Enter the following menus: Powertrain / Hybrid Control / Utility / All Readiness.
- Check the DTC judgment result.
HINT:
- If the judgment result shows NORMAL, the system is normal.
- If the judgment result shows ABNORMAL, the system has a malfunction.
- If the judgment result shows INCOMPLETE or N/A, perform the normal judgment procedure again.
PROCEDURE |
1. | CHECK DTC OUTPUT (HYBRID CONTROL) |
(a) Connect the Techstream to the DLC3. (b) Turn the power switch on (IG).
(c) Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.
(d) Check for DTCs. Powertrain > Hybrid Control > Trouble Codes
|
Result | Proceed to | |
P060694 only is output. |
A | | DTCs except P060694 are output. |
B | (e) Turn the power switch off.
| A |
 | REPLACE HYBRID VEHICLE CONTROL ECU |
| B |
| GO TO DTC CHART (HYBRID CONTROL SYSTEM) | | 
