Toyota Avalon (XX50) 2019-2022 Service & Repair Manual: Driver Seat Control ECU Communication Stop Mode

DESCRIPTION

Detection Item

Symptom

Trouble Area

Driver Seat Control ECU Communication Stop Mode

Any of the following conditions are met:

Communication stop for "D-Seat" is indicated on the "Communication Bus Check" screen of the Techstream.
Click here
Communication stop history for "D-Seat" is indicated on the "Communication Bus Check (Detail)" screen of the Techstream. (The Lost Communication Time value for "D-Seat" is 6 or more.)
Click here
Communication system DTCs (DTCs that start with U) that correspond to "Driver Seat Control ECU Communication Stop Mode" in "DTC Combination Table" are output.
Click here

WIRING DIAGRAM

CAUTION / NOTICE / HINT

CAUTION:

When performing the confirmation driving pattern, obey all speed limits and traffic laws.

NOTICE:

Because the order of diagnosis is important to allow correct diagnosis, make sure to begin troubleshooting using How to Proceed with Troubleshooting when CAN communication system related DTCs are output.
Click here
Before measuring the resistance of the CAN bus, turn the engine switch off and leave the vehicle for 1 minute or more without operating the key or any switches, or opening or closing the doors. After that, disconnect the cable from the negative (-) battery terminal and leave the vehicle for 1 minute or more before measuring the resistance.
After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Click here
After performing repairs, perform the DTC check procedure and confirm that the DTCs are not output again.
DTC check procedure: Turn the engine switch on (IG) and wait for 1 minute or more. Then operate the suspected malfunctioning system and drive the vehicle at 60 km/h (37 mph) or more for 5 minutes or more.
After the repair, perform the CAN bus check and check that all the ECUs and sensors connected to the CAN communication system are displayed as normal.
Click here
Inspect the fuses for circuits related to this system before performing the following procedure.

HINT:

Before disconnecting related connectors for inspection, push in on each connector body to check that the connector is not loose or disconnected.
When a connector is disconnected, check that the terminals and connector body are not cracked, deformed or corroded.

PROCEDURE

1.	CHECK FOR OPEN IN CAN BUS LINES (POSITION CONTROL ECU ASSEMBLY LH BRANCH LINE)

(a) Disconnect the cable from the negative (-) battery terminal.

(b) Disconnect the R32 position control ECU assembly LH connector.

Standard Resistance:

Tester Connection	Condition	Specified Condition
R32-13 (CANP) - R32-14 (CANN)	Cable disconnected from negative (-) battery terminal	54 to 69 Ω

*a	Front view of wire harness connector (to Position Control ECU Assembly LH)

REPAIR OR REPLACE CAN BRANCH LINES OR CONNECTOR (POSITION CONTROL ECU ASSEMBLY LH)

2.	CHECK HARNESS AND CONNECTOR (POWER SOURCE CIRCUIT)

(a) Disconnect the R33 position control ECU assembly LH connector.

(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection	Condition	Specified Condition
R33-2 (E) - Body ground	Cable disconnected from negative (-) battery terminal	Below 1 Ω

*a	Front view of wire harness connector (to Position Control ECU Assembly LH)

(d) Measure the voltage according to the value(s) in the table below.

Standard Voltage:

REPLACE POSITION CONTROL ECU ASSEMBLY LH

REPAIR OR REPLACE HARNESS OR CONNECTOR (POWER SOURCE CIRCUIT)

Toyota Avalon (XX50) 2019-2022 Service & Repair Manual > Parking Assist Monitor System(for Gasoline Model): System Diagram
SYSTEM DIAGRAM Communication Table Sender Receiver Signal Line Radio and Display Receiver Assembly Television Camera Assembly Setting information signal CAN Steering Sensor Television Camera Assembly Steering angle signal CAN ECM Television Camera Assembly Vehicle information signal Reverse signal C ...

Toyota Avalon (XX50) 2019-2022 Owners Manual