Toyota Avalon (XX50) 2019-2022 Service & Repair Manual: Installation

INSTALLATION

CAUTION / NOTICE / HINT

HINT:

• Use the same procedure for the RH side and LH side.
• The following procedure is for the LH side.

PROCEDURE

1. INSTALL FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY

(a) Install the front lower arm bushing stopper to the front lower No. 1 suspension arm sub-assembly.

(b) Install the front lower No. 1 suspension arm sub-assembly to the front frame assembly with the 3 bolts and nut in the order shown in the illustration. Torque: Bolt (1), (2) : 200 N·m {2039 kgf·cm, 148 ft·lbf} Bolt (3) : 135 N·m {1377 kgf·cm, 100 ft·lbf} NOTICE: Because the nut has its own stopper, do not turn the nut. Tighten the bolt with the nut secured.

(c) Connect the front lower No. 1 suspension arm sub-assembly to the front lower ball joint assembly with the bolt and 2 nuts.

Torque:

92 N·m {938 kgf·cm, 68 ft·lbf}

2. INSTALL FRONT FENDER APRON SEAL LH

for HV Model: Click here

for Gasoline Model: Click here

3. INSTALL FRONT FLOOR COVER LH

for HV Model: Click here

for Gasoline Model: Click here

4. INSTALL NO. 2 ENGINE UNDER COVER ASSEMBLY (for HV Model)

Click here

5. INSTALL REAR ENGINE UNDER COVER LH (for Gasoline Model)

Click here

6. INSTALL NO. 1 ENGINE UNDER COVER

for HV Model: Click here

for Gasoline Model: Click here

7. INSTALL FRONT WHEEL OPENING EXTENSION PAD LH

for HV Model: Click here

for Gasoline Model: Click here

8. INSTALL FRONT WHEEL OPENING EXTENSION PAD RH

for HV Model: Click here

for Gasoline Model: Click here

9. INSTALL FRONT WHEEL

Click here

10. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT

Click here

11. PERFORM INITIALIZATION