DESCRIPTION The headlight ECU sub-assembly LH or headlight ECU sub-assembly RH stores a DTC if it detects an internal malfunction.
CAUTION / NOTICE / HINT NOTICE: If the headlight ECU sub-assembly LH has been replaced, it is necessary to synchronize the vehicle information the headlight ECU sub-assembly LH. Click here
PROCEDURE
(a) Connect the Techstream to the DLC3. (b) Turn the power switch on (IG). (c) Turn the Techstream on. (d) Enter the following menus: Body Electrical / HL AutoLeveling or HL AutoLeveling (Sub) / Trouble Codes. (e) Clear the DTCs. Body Electrical > HL AutoLeveling > Clear DTCs Body Electrical > HL AutoLeveling (Sub) > Clear DTCs
(a) Connect the Techstream to the DLC3. (b) Turn the power switch on (IG). (c) Wait for at least maximum 15 minutes. (d) Turn the Techstream on. (e) Enter the following menus: Body Electrical / HL AutoLeveling or HL AutoLeveling (Sub) / Trouble Codes. (f) Check for DTCs. Body Electrical > HL AutoLeveling > Trouble Codes Body Electrical > HL AutoLeveling (Sub) > Trouble CodesOK: DTC B242C and B242D are not output.
|
Toyota Avalon (XX50) 2019-2022 Service & Repair Manual > Side Airbag Sensor(for Center Pillar): Installation
INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The following procedure is for the LH side. PROCEDURE 1. INSTALL SIDE NO. 1 AIRBAG SENSOR (a) Check that the engine switch (for Gasoline Model) or power switch (for HV Model) is off. (b) Check that the cab ...
