INSPECTION PROCEDURE 1. INSPECT POWER WINDOW REGULATOR MOTOR ASSEMBLY (FOR REAR LH DOOR)
(a) Connect a positive (+) lead from the auxiliary battery to connector terminal 2.
NOTICE: Do
not connect a positive (+) lead from the auxiliary battery to any
terminal other than terminal 2 to avoid damaging the pulse sensor inside
the motor. |
|
*a | Component without harness connected
(Power Window Regulator Motor Assembly (for Rear LH Door)) |
*b | Clockwise |
*c | Counterclockwise |
*d | Motor gear | | |
(b) Connect a negative (-) lead from the auxiliary battery to connector terminal 1 and 7 or 10.
(c) Check that the motor gear rotates smoothly as follows: OK:
Measurement Condition | Specified Condition |
- Connect a positive (+) lead from the auxiliary battery to terminal 2,
connect a negative (-) lead from the auxiliary battery to terminal 1,
and keep them connected for 3 seconds or more.
- With terminals 2 and 1 connected, connect a negative (-) lead from the auxiliary battery to terminal 10.
| Motor gear rotates clockwise |
- Connect a positive (+) lead from the auxiliary battery to terminal 2,
connect a negative (-) lead from the auxiliary battery to terminal 1,
and keep them connected for 3 seconds or more.
- With terminals 2 and 1 connected, connect a negative (-) lead from the auxiliary battery to terminal 7.
| Motor gear rotates counterclockwise |
- If the result is not as specified, replace the power window regulator motor assembly (for rear LH door).
CAUTION: Initialize the power window control system after installing the power window regulator motor and regulator assembly.
2. INSPECT POWER WINDOW REGULATOR MOTOR ASSEMBLY (FOR REAR RH DOOR)
(a) Connect a positive (+) lead from the auxiliary battery to connector terminal 2.
NOTICE: Do
not connect a positive (+) lead from the auxiliary battery to any
terminal other than terminal 2 to avoid damaging the pulse sensor inside
the motor. |
|
*a | Component without harness connected
(Power Window Regulator Motor Assembly (for Rear RH Door)) |
*b | Clockwise |
*c | Counterclockwise |
*d | Motor gear | | |
(b) Connect a negative (-) lead from the auxiliary battery to connector terminals 1 and 7 or 10.
(c) Check that the motor gear rotates smoothly as follows: OK:
Measurement Condition | Specified Condition |
- Connect the positive (+) lead from the auxiliary battery to terminal 2,
connect a negative (-) lead from the auxiliary battery to terminal 1,
and keep them connected for 3 seconds or more.
- With terminals 2 and 1 connected, connect a negative (-) lead from the auxiliary battery to terminal 10.
| Motor gear rotates counterclockwise |
- Connect a positive (+) lead from the auxiliary battery to terminal 2,
connect a negative (-) lead from the auxiliary battery to terminal 1,
and keep them connected for 3 seconds or more.
- With terminals 2 and 1 connected, connect a negative (-) lead from the auxiliary battery to terminal 7.
| Motor gear rotates clockwise |
- If the result is not as specified, replace the power window regulator motor assembly (for rear RH door).
CAUTION: Initialize the power window control system after installing the power window regulator motor and regulator assembly. |