Toyota Avalon (XX50) 2019-2022 Service & Repair Manual: Installation

INSTALLATION

CAUTION / NOTICE / HINT

HINT:

• Use the same procedure for the RH side and LH side.
• The following procedure is for the LH side.

PROCEDURE

1. PRECAUTION

NOTICE:

After turning the engine switch (for Gasoline Model) or power switch (for HV Model) off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

Click here

2. INSTALL POWER WINDOW REGULATOR MOTOR ASSEMBLY

NOTICE:

The regulator arm must be below the intermediate position when installing the power window regulator motor assembly.

(a) Using a T25 "TORX" socket wrench, install the power window regulator motor assembly with the 3 screws.

Torque:

5.39 N·m {55 kgf·cm, 48 in·lbf}

HINT:

When replacing a power window regulator motor assembly, a new power window regulator motor assembly uses self-tapping screws to thread new installation holes when the self-tapping screws are inserted.

3. INSTALL REAR DOOR WINDOW REGULATOR ASSEMBLY

Click here

4. INSTALL REAR DOOR GLASS SUB-ASSEMBLY

Click here

5. INSTALL REAR DOOR REAR GUIDE SEAL

Click here

6. CONNECT REAR DOOR WEATHERSTRIP

(a) Engage the clip and connect the rear door weatherstrip.

7. INSTALL REAR DOOR REAR LOWER WINDOW FRAME SUB-ASSEMBLY

Click here

8. INSTALL REAR DOOR GLASS RUN

Click here

9. INSTALL REAR DOOR NO. 2 SERVICE HOLE COVER

Click here

10. INSTALL REAR DOOR INNER GLASS WEATHERSTRIP

Click here

11. INSTALL REAR DOOR SERVICE HOLE COVER

Click here

12. INSTALL REAR DOOR NO. 1 TRIM BRACKET

Click here

13. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY

Click here

14. INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR UPPER ARMREST BASE PANEL

Click here

15. INSTALL REAR DOOR TRIM ASSEMBLY COVER

Click here

16. INSTALL REAR DOOR ARMREST COVER SUB-ASSEMBLY

Click here

17. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

for A25A-FXS:

Click here

for 2GR-FKS:

Click here

18. INSTALL LUGGAGE TRIM SERVICE HOLE COVER (for HV Model)

Click here

19. INITIALIZE POWER WINDOW CONTROL SYSTEM

for Gasoline Model: Click here

for HV Model: Click here

20. INSPECT POWER WINDOW OPERATION

for Gasoline Model: Click here

for HV Model: Click here