Toyota Avalon (XX50) 2019-2022 Service & Repair Manual: Removal

REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during rear seat outer belt assembly removal/installation are shown below.

CAUTION:

• Wear protective gloves. Sharp areas on the parts may injure your hands.
• Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

  Click here

  

CAUTION:

• Wear protective gloves. Sharp areas on the parts may injure your hands.
• Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

  Click here

  

PROCEDURE

1. PRECAUTION

NOTICE:

After turning the engine switch (for Gasoline Model) or power switch (for HV Model) off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

Click here

2. REMOVE LUGGAGE TRIM SERVICE HOLE COVER (for HV Model)

Click here

3. REMOVE SPARE WHEEL COVER ASSEMBLY (w/ Seat Heater System)

Click here

4. REMOVE LUGGAGE COMPARTMENT INNER TRIM PAD (w/ Seat Heater System)

Click here

5. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

for A25A-FXS:

Click here

for 2GR-FKS:

Click here

CAUTION:

• Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
• If an airbag deploys for any reason, it may cause a serious injury.

6. DISCONNECT REAR CENTER SEAT OUTER BELT ASSEMBLY

Click here

7. REMOVE REAR SEAT CUSHION ASSEMBLY

Click here

8. REMOVE REAR SEAT CUSHION LOCK HOOK

Click here

9. REMOVE REAR SIDE SEATBACK ASSEMBLY LH

Click here

10. REMOVE REAR SIDE SEATBACK ASSEMBLY RH

HINT:

Use the same procedure as for the LH side.

11. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP LH

(a) Disconnect the rear door opening trim weatherstrip LH.

12. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP RH

HINT:

Use the same procedure as for the LH side.

13. REMOVE ROOF SIDE RAIL GARNISH ASSEMBLY LH

Click here

14. REMOVE ROOF SIDE RAIL GARNISH ASSEMBLY RH

HINT:

Use the same procedure as for the LH side.

15. REMOVE ROOF SIDE INNER GARNISH LH

Click here

16. REMOVE ROOF SIDE INNER GARNISH RH

HINT:

Use the same procedure as for the LH side.

17. DISCONNECT REAR SEAT 3 POINT TYPE BELT ASSEMBLY LH

(a) Remove the bolt to disconnect the floor anchor of the rear seat 3 point type belt assembly LH.

18. DISCONNECT REAR SEAT 3 POINT TYPE BELT ASSEMBLY RH

HINT:

Use the same procedure as for the LH side.

19. REMOVE CENTER STOP LIGHT SET

Click here

20. REMOVE REAR SEAT SHOULDER BELT COVER

(a) Disengage the 2 claws and 2 guides to remove the rear seat shoulder belt hole cover. HINT: Use the same procedure for the other rear seat shoulder belt hole covers.

21. REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY

(a) Fold the rear seatback assembly LH and rear seatback assembly RH forward.

(b) Remove the 2 clips.

(c) Disengage the 3 clips and 5 guides.

(d) Pass the 3 rear seat belt floor anchors through the package tray trim panel assembly then remove the package tray trim panel assembly.

22. REMOVE REAR SEAT 3 POINT TYPE BELT ASSEMBLY LH

(a) Using a screwdriver, pull out the locking button as shown in the illustration to release the lock and disconnect the pretensioner connector. HINT: Tape the screwdriver tip before use.

*a Protective Tape *b Locking Button *c Release

(b) Remove the 2 bolts.

(c) Disengage the guide to remove the rear seat 3 point type belt assembly LH.

23. REMOVE REAR SEAT 3 POINT TYPE BELT ASSEMBLY RH

HINT:

Use the same procedure as for the LH side.

24. REMOVE REAR SEAT BELT RETRACTOR COVER LH

(a) Remove the rear seat belt retractor cover LH as shown in the illustration.

Remove in this Direction

25. REMOVE REAR SEAT BELT RETRACTOR COVER RH

HINT:

Use the same procedure as for the LH side.