Toyota Avalon (XX50) 2019-2022 Service & Repair Manual: Removal

REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during rear seatback lock assembly removal/installation are shown below.

CAUTION:

• Wear protective gloves. Sharp areas on the parts may injure your hands.
• Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

  Click here

  

CAUTION:

• Wear protective gloves. Sharp areas on the parts may injure your hands.
• Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

  Click here

  

PROCEDURE

1. REMOVE REAR SEAT ASSEMBLY

Click here

2. REMOVE CENTER STOP LIGHT SET

Click here

3. REMOVE LUGGAGE COMPARTMENT INNER TRIM PAD (w/o Seat Heater System)

(a) Remove the luggage compartment inner trim pad.

4. DISCONNECT REAR SEAT 3 POINT TYPE BELT ASSEMBLY LH

Click here

5. DISCONNECT REAR SEAT 3 POINT TYPE BELT ASSEMBLY RH

HINT:

Use the same procedure as for the LH side.

6. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP LH

Click here

7. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP RH

HINT:

Use the same procedure as for the LH side.

8. REMOVE ROOF SIDE RAIL GARNISH ASSEMBLY LH

Click here

9. REMOVE ROOF SIDE RAIL GARNISH ASSEMBLY RH

HINT:

Use the same procedure as for the LH side.

10. REMOVE ROOF SIDE INNER GARNISH LH

Click here

11. REMOVE ROOF SIDE INNER GARNISH RH

HINT:

Use the same procedure as for the LH side.

12. REMOVE REAR SEAT SHOULDER BELT COVER

Click here

13. REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY

Click here

14. REMOVE ROOM PARTITION BOARD LH

(a) Remove the clip.

(b) Disengage the 2 claws.

(c) Disengage the 4 clips to remove the room partition board LH.

15. REMOVE ROOM PARTITION BOARD RH

(a) Remove the 2 clips.

(b) Disengage the 5 clips to remove the room partition board RH.

16. REMOVE REAR SEATBACK LOCK ASSEMBLY LH

(a) Release the stopper and disengage the guide as shown in the illustration.

*a	Stopper
	Release
	Remove in this Direction (1)
	Remove in this Direction (2)

(b) Remove the 2 nuts and rear seatback lock assembly LH.

17. REMOVE REAR SEATBACK LOCK ASSEMBLY RH

HINT:

Use the same procedure as for the LH side.