INSTALLATION PROCEDURE 1. INSTALL NO. 1 INDOOR ELECTRICAL KEY ANTENNA ASSEMBLY (a) Engage the clamp to install the No. 1 indoor electrical key antenna assembly. NOTICE: Be careful when installing the No. 1 indoor electrical key antenna assembly. If the No. 1 indoor electrical key antenna assembly is dropped, replace it with a new one. (b) Connect the connector. 2. INSTALL REAR SEAT CUSHION LOCK HOOK Click here 3. INSTALL REAR SEAT CUSHION ASSEMBLY Click here 4. CONNECT REAR CENTER SEAT OUTER BELT ASSEMBLY Click here 5. INSTALL LUGGAGE COMPARTMENT INNER TRIM PAD (w/ Seat Heater System) Click here 6. INSTALL SPARE WHEEL COVER ASSEMBLY (w/ Seat Heater System) Click here 7. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL for A25A-FXS: Click here for 2GR-FKS: Click here 8. INSTALL LUGGAGE TRIM SERVICE HOLE COVER (for HV Model) Click here 9. PERFORM DIAGNOSTIC SYSTEM CHECK for Gasoline Model: Click here for HV Model: Click here |
Toyota Avalon (XX50) 2019-2022 Service & Repair Manual > Sfi System: Knock Sensor 1 Bank 1 or Single Sensor Circuit Short to Ground (P032511)
DESCRIPTION A flat-type knock control sensor (non-resonant type) has a structure that can detect vibrations between approximately 5 and 15 kHz. The knock control sensor is fitted onto the engine block to detect engine knocking. The knock control sensor contains a piezoelectric element which generate ...
