Toyota Avalon (XX50) 2019-2022 Service & Repair Manual: Blind Spot Monitor Beam Axis Misalignment (C1AFA)

Toyota Avalon (XX50) 2019-2022 Service & Repair Manual / Audio, Visual, Telematics / Park Assist / Monitoring / Intelligent Clearance Sonar System(for Gasoline Model) / Blind Spot Monitor Beam Axis Misalignment (C1AFA)

DESCRIPTION

This DTC is stored when the clearance warning ECU assembly receives a signal from the blind spot monitor system via CAN communication indicating blind spot monitor beam axis misalignment.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

C1AFA

Blind Spot Monitor Beam Axis Misalignment

The clearance warning ECU assembly receives a signal from blind spot monitor system indicating blind spot monitor beam axis misalignment.

Blind spot monitor system

PROCEDURE

1.

CHECK FOR DTC

(a) Using the Techstream, check for DTCs according to the prompts on the screen.

HINT:

After turning the engine switch from off to on (IG), wait 4 seconds or more before checking for DTCs.

Body Electrical > Advanced Parking Guidance/ICS/Intuitive P/A > Trouble Codes

(b) Clear the DTCs according to the screen on the Techstream.

Body Electrical > Advanced Parking Guidance/ICS/Intuitive P/A > Clear DTCs

(c) Recheck for DTCs.

Body Electrical > Advanced Parking Guidance/ICS/Intuitive P/A > Trouble Codes

HINT:

  • DTC C1AFA is stored when a malfunction signal sent from the blind spot monitor system is detected.
  • If the malfunctioning part has been repaired or replaced before rechecking for DTCs, DTC C1AFA will not be output again.
  • If DTC C1AFA is output frequently, duplicate the conditions that cause the problem symptoms and perform troubleshooting again, even though the DTC was not output when rechecking for DTCs.

    Click here

Result

Proceed to

DTC C1AFA is output

A

DTC C1AFA is not output

B
A

GO TO BLIND SPOT MONITOR SYSTEM

B

USE SIMULATION METHOD TO CHECK

    Blind Spot Monitor Beam Axis Inspection Incomplete (C1AF9)

    Communication Error From Clearance Sonar ECU to VSC (C164B)

    See More:

    Toyota Avalon (XX50) 2019-2022 Service & Repair Manual > Motor Generator Control System: DC/DC Converter Voltage Sensor "A"(VL) Circuit Intermittent (P314F1F)
    DTC SUMMARY MALFUNCTION DESCRIPTION This DTC is stored if the value of "VL Voltage" fluctuates excessively. The cause of this malfunction may be one of the following: Area Main Malfunction Description Hybrid vehicle transaxle assembly Open or short circuit in the motor or generator coils Motor (MG2) ...

    Toyota Avalon (XX50) 2019-2022 Owners Manual

    Toyota Avalon (XX50) 2019-2022 Service & Repair Manual

    © 2025 Copyright www.tavalon.net
    0.0139